BILITOOLS 7-Piece Windshield Removal Tool Kit for Classic Vintage Car Windscreen Remover Set

Worked perfectly

excelente

Not bad for the cost. Big complaint is it did not come in a case just a foam tray. And the wire that comes with that is very very weak and cheap. But I can't complain overall decent value.

Did what it said. Really just used the wire and the tool to push the wife through. By any means it no simple task. Patients is key. If you use the blade it may seem slow but what I did another time was heated the blade with a torch and then pulled through until it cooled off. Goes through the seal like butter when hot. Don't get pissed if the wire breaks. It will happen a few times. Just check what it snagged on and adjust your angle. Also important you might think going back and forth really quick is what's required. Like a saw but what you really want to do is hold one end tight. Not moving that hand and then pulling back with the other hand in a single pull. If it gets stuck and you can't pull restart by pulling the wire back then hold and repeat. This was how I quickly got it out. It does require some strength but once it starts moving it moves. Avoid pulling up. Don't let the corners allow you to rest the wire on the glass to hit the angle. You will break that corner quick doing so

Window is out... wire broke seven times... lost both e-clips during wire changes. Not like old piano wire, a guitar string won't break! The double sided blade works well to pull trim before using wire to cut out. Did this solo wishing had a helper to saw. Just took several punctures and change up direction. Old glass cracked into fifty webs. Came out in a single piece thankfully. As for urethane removal from pinchwelds. Don't waste your time with this kit! Purchase a hot air gun say $15, You'll scratch your paint trying. Use a razor scrapper on used replacement then primer b4 install. New glass only needs primer 1st. For frame use a 1" long scrapper heat gun at angle stay ahead peals even large swatches . Use hot gloves to pull strip off. Touch up and primer. Hot urethane 150 to 180 caulk easy. Install windshield with trim attached. Wait 24 hrs. They say fast cure... a bump in the cold it will leak.

The blades lasted about 6-8 inches and was bent out of shape, as per value, it’s extremely overpriced for what you’re getting, extremely difficult to use, falls apart in no time. Not worth $10, would not recommend this product at all.

Everything I needed to remove my windshield.

Product as advertisded, simple to use.