LightDims White Dims Dimming/Softening Sheets for Harsh LED Lights 8"x10.5" Size (1 Sheet) Neutral Color & (1 Sheet) of Free Mystery Gift. Packaging May Vary

works really well, Adhesive quality is perfect, sticky enough to get on fixture and rub out air bubbles, but easy enough to remove if a re-due is needed. I put two layers over my painfully bight LED fixture and this seems to do the trick. Will recommend, will buy again as I am forced to add LED fixtures to my space.

One sheet was all we needed for our 29’ travel trailer. Just pop the light covers off your led lights, tape a small piece that covers all the bulbs. You don’t have to worry about wrinkles or cutting straight lines because when you put the covers back on it hides all that. They provided a beautiful ambiance in our TT for 2 years of full-time living while still being bright enough to feel like the room was lit. When we traded our trailer in to upgrade, take the covers off and tue tape peels right off with zero trouble or residue. One of the most impactful yet easiest upgrades we made to our RV and it was completely reversible when we were ready to move on. Highly recommended.

This sheet is much more translucent than the smaller sheets that I tried. https://www.amazon.com/dp/B0BLSHG6CS?ref=ppx_yo2ov_dt_b_product_details&th=1 On a ceiling LED fixture it dims a good bit and still maintains the warm white color. Not at all yellowish like the small sheets. Would be 5 stars, but really expensive for one 81/2 x 11 sheet.

Very disappointed with my purchase. Complete disaster. It arrived with no instructions, not even any cardboard backing to keep the sheets from rolling up. It was literally impossible to apply the sheets without any wrinkles, which could be seen right through the light fixture. This problem was exacerbated by the fact that the light fixture had a curved surface. Completely unusable, just ended up replacing the light fixture with a smaller one that wasn't as bright. Don't waste your money!!!

Overpriced for 2 pieces of 8.5x11 paper that easily rips. Works ok, does dim the bright LED lights somewhat. Not a terrible product, but could be a lot better!

This product does what it says. I have an outdoor fixture that goes on at dusk and off at dawn. After I had it installed I found that it was so bright that - not I couldn't look at it - I couldn't face it! I researched and found this great dimmer. Simple yet so effective. I just cut the sheet to approximately the size of the bulb and peeled the sticker off and applied it to the light. Then I trimmed it with a razor so it was exact. Same as you would use a label - just peel and stick. Now it's bright, but I can look the bulb right in the eye. I would highly recommend this product for a LED fixture.

After replacing my 10 Halogen lights with LED’s , my ability to dim too far would cause lights to either flicker, or power off. I had to adjust the dimmer higher than I wanted. The LightDims were the perfect answer! They were very easy to install, using a pen to trace the shape, and scissors to cut. The lights have the perfect color balance and diffuse evenly. I now have total control on how much to dim them. They arrived today, ahead of schedule, and an hour later my LED’s look exactly like my halogens did, at a fraction of the wattage. Thanks for making a great product!

The product is a thin sticky film supported by a backing sheet. To apply I found a glass with the same diameter as my flat LED. Put the glass over the sheet and cut around it. If you use a sharp (new) single edged razor blade you can cut just the film and peel it off the backing sheet. I needed to reposition the film a couple of times to get it perfect. But that actually worked out better because the film lost some of its stickiness. Once applied the film cut brightness of the LED slightly and eliminated the glare. I do see where this might be a challenge to apply on curves surfaces.