1/2 "3/4" 1"inner top water inlet automatic float valve water level control valve, used for solar water tank tower pool (3/4")

Needed an autofill valve for my Aquascape skimmer box. Because of space constraints with a check valve plus an auto shutoff controller inside the skimmer along with the pump, the hinge-type autofill which I had previously was problematic. That device was long and touched the check valve or the auto shutoff mechanism causing the float to stick. The old valve also leaked even when the float was fully up. This XUEE valve resolved all of the problems listed above. It is compact, easily installed and provides positive shutoff control. I am very satisfied and will purchase another to have as a spare.

It’s working in my fountain no issues has been running for months. My only comment would be it needs a better mounting system I had to get creative

I struggled for years to find a valve that I could install into my Aquascapes skimmer that I could set and leave. This one has worked flawlessly now for two consecutive years. Thank You!

Excellent

Used this to fill the holding tank for my automatic chicken watering setup. I needed a compact design to work inside of my holding tank made of 4 inch pvc pipe, and this one fit perfectly with room to spare. Great value for the money.

Installed this in water tank for coffee maker. This is totally submerged in water and water is still flowing. Flooded kitchen floor. This is a replacement for a float that was installed in tank nearly 10 years ago that finally went bad., that is no longer made. There is a water filter in the supply line to keep any debris from getting to float. Will be returning.

Después de 2 años falla, no sella bien, una semana atrás se me inundó mi casa

Buen producto

It’s been working for the last four weeks so far so good

tres utile

المنتج جيد و عملي ولكن انتظر نتائج الاستخدام بعد التركيب فهو تحت الاختبار خلال هذه الفترة

using it in my fish pond...for last few months appears fine ...so far

The water inlet is too short to accommodate all of - tank wall, gasket, nut and incoming 1/2 BSP nut + gasket. 1. There is no nut in the set. 2. You can just about manage to have it assembled onto a very thin tank if you skip the tank wall gasket (very bad idea) and shave 3-4mm off an old plastic toilet set nut. If the tank is thicker you are out of luck. As is, it is not fit for the intended purpose - to refill a tank. It needs at least 5-10mm more on the inlet 1/2 BSP side.