Sewell Ghost Wire 2.0, Super Flat Adhesive Speaker Wire, 18 AWG, 4 Conductor, 50 ft. Spool, White

Ran under the carpet to run my rear speakers. Don't know its there when you walk on it. Great solution to hide the wires.

The idea itself is great. However, in practice, not so much. The wiring and tape mixture is a great idea. In a room with 3 contiguous walls, it is a great way to run wires to rear channels. However, the adhesive is garbage. When putting it on, if you pull back too much of the removable layer to expose the adhesive side, you run the risk of it touching the wall or baseboard. The adhesive with remove and damage the paint and then buckle when trying to attach properly. Also, in less than 12 hours, the adhesive, the same adhesive that would pull off paint, was completely pulled from the wall. I woke up the next morning to only sections of the tape remaining attached to the wall. I followed the installation instructions to the letter, cleaning the surface thoroughly and ensuring the surface was clean and dry. To fix the issue, I purchased Gorilla double sided tape from my local hardware store and used that to adhere the wiring tape to the wall. This has worked perfectly. Since there are several reviews calling out adhesion issues, maybe Sewell needs to partner with Gorilla Glue to use a better two sided tape or adhesion....

Seemed like a good fit for my situation. I really didn't want to run wire through so many walls. After cleaning the walls, installing and painting it looked reasonably good. Sure there was a visible bump, but with pictures and knick-knacks breaking up the visual space it wasn't noticeable unless you were looking for it. Over time (several months to a few years), however, the wire just started peeling off. It took a lot of time to be sure, but especially on exterior walls (which get colder than the ambient temperature of the room) they came completely detached in sections. Still using them while I look for a better solution, but it looks ridiculous on the exterior wall where it's almost completely fallen off.

This stuff works great, and I've no complaints about performance. I do however want to mention that the adhesive used is very mighty, and will rip latex paint off the wall easily if you attempt to remove it. While some might consider this a feature, I think it deserves a note, and I would select something easier to remove if I could find it. Overall for my project, I could have gotten by with some white colored channel, but this does look a lot better.

Exactly what I expected. It’s great and easy to install

Great product, ingenious design, easy to install over existing walls or base molding.

I would have loved to give this a better review, but my experience doesn't reflect the others. Followed the installation instructions perfectly and even did extras to make sure it stuck right (used alcohol to make sure no dust/debris). Hung everything up, smoothed out all the air bubbles, looked great, then a few hours later all came falling down. Tried it again, used duct tape to keep it in place to allow the glue to cure, same thing. Reached out to Sewell... "Your problem is most likely because you have textured walls"... Man, I wish I knew that before I spent the money on this stuff. Maybe a disclaimer? Oh well. Back to the drawing board.

It's not too easy to add the wire to the wall. Turn 90 Degrees is a challenge, but at the bottom line my surround speakers are well connected, and the wire is well dissimulated when you paint it.

Très mauvais produit. Me reste pas coller plus de quelques heures.