3M 38315 Panel Bonding Adhesive - 37.5 ml

Follow directions and you will never use your might welder for joining panels as this holds just as well (or even better) without burning protective coatings which then allows rust to form. You do need to grind any coatings off from the two adjoining surfaces providing a bare metal roughened surface for a good bite. The panel adhesive forms a waterproof barrier where moisture cannot get to the metal surface. If it does, you are not using the product correctly. I use a few sheet metal screws as needed to hold the panel in place until the epoxy cures. A small amount of adheasive should ooz out along the seam edges ensuring that you have used an adequate amount. Then I grind the heads off and roughened the surface around the seam then apply a good quality waterproof short stran filler. Shape, sand and finish as needed. Been using this product for years now. Had a small quarter panel patch repair to do on a 1995 Toyota. This was just the right amount to do the job.

初めて使用したけど良いと思う

Great product, just what I need to glue on a cab corner on my jimmy. Proffesional grade, a little expensive but cheaper than the alternative.

使い切れるボンドの量が、良かったです。

Took forever, and I would need 3 of these to glue a quarter panel on , real tiny