キング砥石 キングデラックス No.1000(標準型) 207x66x34 粒度:#1000 中仕上げ用

他のメーカーのばかり買ってましたが、明らかに全体が均一に出来ていて感心しました。少し厚めなのも良いと思います。

自宅の包丁研ぎ用に、6000番の仕上げ砥石とセットで購入。 二つ合わせて良い品でした。

中砥石用で購入！ しっかり面が平らで研ぎ味も良く、包丁の切れ味も日常で野菜などを切る分には問題なし！

日々の包丁研ぎに最適。仕上げはシャプトン12000で鏡面にしてます。 キング1000番→シャプトン2000番→キング6000番→シャプトン12000番の順です。 粘りと吸い付きが自分にはあってました。

家内が使う包丁を週一くらいで研いでいます。厚さもあり使いやすいと思います。この後＃3000の仕上げ砥石で仕上げています。

プロ用、毎日研ぐと2年で終わり。シャプトンより使える、研ぐのは、荒砥かけてから。

厚さがあるので吸水と乾燥に時間がかかります。でもこの厚さはずっと使えてお得です。台座はシャプトンの刃の黒幕のケースがほぼピッタリで使えます。 使い心地は問題なく、安定のキングさんの1000番なのでとても良いです。

冬場だからでしょうがなっかなかに乾かすのに時間かかりました

Está es una muy buena piedra para iniciarse en el afilado de cuchillo, ya llevo utilizando está piedra más de un año y está perfecta.

It’s an essential item for me !!! Good quality!!

Broken 💔

Sharpens quickly with the 300 grit.

Quick: Get this stone, it can replace everything up to a 600-level stone. It is hard, cuts super steels and high HRC, it can get a fine edge if you use light pressure, and could hypothetically replace all your stones if you only needed a toothy edge. It will shave hair after this stone, and it cuts faster than a Chosera 600. I got this King 300 stone, hoping it would be another great value from King, and it exceeded my expectations. I have sharpened and/or repaired chips in at least 10 knives on this so far. It is a fantastic stone. It is a hard stone, no real mud build-up. It cuts fast, using a push-pull technique from tip to heel in a continuous edge-wise slide across the length, using the top-to-bottom of the stone for each section before moving on, I got a burr in 1-2 passes on everything but my VG-10 knife, that took 2-3. I was re-beveling it to a shallower bevel, so take that number as an excessive amount of sharpening. I am sure I could have got it in less if I wasn't excessively beveling. I even sharpened my Cold Steel Barong Machete on this little thing and it'll cut paper with the stropped finish this stone leaves! for the $30, this is great! No noticeable dishing of the stone at this time, and I have checked it. still flat, still cuts great, and no load. I thought the Barong, being 1055 steel tempered to a lower Rockwell, might clog it up, but a quick rinse and a couple of light passes with a rust eraser, and it looks new. CONS: The color of the stone seems to mask any swarf. You can see the knife shavings, but barely. I thought at first there wasn't any stone swarf, but the marathon session on the machete showed a little stone swarf buildup. Still hard to see the buildup so adjusting for it is tough. But it really cuts fast, and if you rinse between sides, it won't matter much. Not many other cons except it is close in price to the Shapton Pro 120, which is supposed to also be a good stone, but will wear fast. This does wear down, after many sharpenings, I have found this to wear a bit, but it still cuts D2, M390, VG-10, and anything less difficult with ease. For those who doubt the Splash-N-Go nature of this stone, if you look at the photos, you can see where I put a layer of water on top of the stone, came back 3 minutes later, and the stone was drying on the edge, and was dry in the middle, and there is still a perfectly mirror-like layer of water standing on top of the stone. It doesn't get much more splash-n-go than that. I still soak it for about 30 seconds, just to make sure the thing is wet where it needs to be. It regularly dries while using it, and only the surface where water keeps contacting stays damp. It dries in a matter of hours. Because of the barely noticeable slowdown when using my 60-62 HRC VG-10 knife, I would reduce this rating to 4.5 stars. As I cannot, I rounded up. This is a great stone. If you are looking for a value coarse stone, this is a fantastic one, just buy it! King: When can I get my Deluxe 1200 in a splash-n-go like this?? the thing I hate most about my 1200 is the long soak and long drying time (and narrow width), so getting the same kind of finish from a splash-n-go that wears as slowly as this one would be amazing! especially if you can keep the amazing price points King is well known and regarded for. UPDATE: have used BD1n as well on this, it is fantastic. I cannot say enough good things about this stone. Out of the box I used it to flatten my 1200 Deluxe King, which it did nicely, even if it was just out of level by the thickness of some printer paper, it served to flatten the 300 stone enough to get the outer layer off and the real stone working. My outdoor knives love this stone, as a quick strop after this stone leaves a nice toothy edge for camping type use and still keeps it sharp enough to easily cut gauze and other critical tasks. I am contemplating buying another one just to have it forever. Update 7/2019: This stone keeps amazing me! My M390 blade hasn't worn it down, and it can get so smooth from stropping on it that is is smoother than my Chosera 600! I thoroughly enjoy using this stone, and its convenience as well as usability. I seriously could probably use only this stone and it would make a knife sharp enough for most anyone if they weren't a sushi chef or something. I used a kitchen knife sharpened only on this and final strop on newsprint for over 2 weeks in my kitchen. A lovely, lovely stone