Real 18AWG 10 Pairs DC Power Pigtail Cable Male & Female + 10 Pairs Connector

These cables seem to be of good quality, and did the job. Thank you!

You get a lot for your money. Only issue is that the wire size is 0.6mm2. I thing that is closer to 20 awg wire than 18 awg, but fine for all of my needs. Plus you get 10 sets of the screw type connectors which you could attach thicker wire to.

The wire on the pigtails ARE somewhat heavier gauge wire than the ones I have bought from different sources here at Amazon previously, although they don't quite make 18 Ga... Closer to 19Ga (actual diameter is 0.96mm / 0.0365 in.) Be careful when preparing to install these: The wire insulation doesn't 'zip': If you just pull them apart you will rip one side of the insulation off in the split... usually the red side, leaving the copper wire bare for ~1/3 the diameter for the length of the split. So, for best results (carefully) use a razor blade or very sharp, thin knife to separate the insulation. The screw terminal adapters are a little crude in fit and finish, (especially the female ones) but they work OK. Despite the slight negatives mentioned above I DO consider this package to be an excellent bargain.

These connectors are great.

They work as intended.

THESE CONNECTORS ARE SO HANDY WHEN INSTALLING WIRING. I USED THEM TO PUT IN A BACK-UP CAMERA IN MY SUV. I BOCHED A COUPLE OF THEM AND LEARNED 2 THINGS. GET A SCREWDRIVER THAT FITS WELL SO YOU CAN REALLY TIGHTEN DOWN THE SCREWS. AND, IF YOU HAVE TROUBLE INSERTING A WIRE INTO THE CONNECTOR, GET A SMALL SCREWDRIVER OR SOMETHING AND STICK IT IN THE CONNECTOR PLUS OR MINUS OPENING (WHICHEVER YOUR WORKING ON) AND FORCE IT OPEN SO YOU CAN GET YOUR WIRE IN. TOOK ME A WHILE TO REALIZE THAT SOME OF THESE TEND TO CLOSE UP A BIT, ESPECIALLY IF YOU'VE BEEN WORKING WITH IT A WHILE. JUST FORCE IT OPEN, INSERT YOUR WIRE, TORQUE THE SCREW DOWN AND IT SHOULD WORK FINE.

I was doing a bunch of small DC projects and was going to buy just a few of these, but this package gave me everything I needed to do a lot more than just a one or two project I had in mind highly recommend

I only have one slight complaint A lot of the connections feel a little loose and you have to bend the connectors or the prong to get it to fasten together snug. I was concerned of how well the clamps would hold the wire but they proved to be outstanding as long as you use The right gauge wire (see the pic). if you want to use a lighter gauge wire then it helps to apply solder to the wire prior to installing it in the clamps the solder makes the wires a little thicker and make the connections much more secure. It’s definitely a good buy but don’t expect premium quality. Some are bent a few are straight. I would recommend useing a fingertip type of screw driver ( nothing that rests in The palm of your hand while in use )A standard screwdriver allows you to over tighten and strip the screws. Don’t worry they still grab very well. When I tested them they held over 30 lb of weight before they finally failed and the failure point was not the screw connectors but the plastic housing itself split in half

esperaba algo menos robusot, que buena calidad de producto, cable mas grueso de lo esperado y buen acabado en los conectores, recomendado

No he encontrado en el mercado un producto con la relación calidad precio similar a este, recomendado al 100%