5 Meter 6mm Width GT2 Timing Belt for Reprap Delta 3D Printer Kossel Rostock

So far this has been an improvment over my Anet A8's original belts. These are much more flexible and have a nicer, rubbery feel. I was also able to install 3d printed belt tensioner with these belts. I have seen a 10-20% increase in print quality.

Really good belt that worked great on a Reprapguru i3 v2 3d printer. I will definitely buy again when needed. Had enough belt left over to replace again if needed.

Bought this for my Tronxy X5S corexy 3d printer. This was enough for both belts on this fairly big printer (330x330mm print bed) with a negligible scrap left over. Seems pretty good stuff. Is certainly fiber reinforced which should not stretch like the steel reinforced belts that came with the kit, and the price was right.

This belt is steel reinforced. I ordered this one because it was advertised as fiberglass reinforced to replace steel belts that broke after a very short time. I'm going to use it and just reduce tension.

So far these have been some really sturdy belts. Other knockoff GT2 belts I purchased ended up breaking after a couple weeks of printing. These ones are still going strong.

Good quality belt, perfect fit for the Anet A8. Gave me a nice bump in quality, but a properly tensioned stock belt wasn’t too bad.

Installed on my 3D printer, and only made it through 1 print before a belt snapped.

Nice belt. Very flexible and stretch-resistant