Glasses Spacer Protector for Meta Quest 3, Blue Light Blocking Glasses for Oculus Quest 3, VR Protector Accessories Anti-Scratch Ring Prevent Eyeglass from Scratching for Meta Quest 3

Very best lens it also have fog wipe

Low quality. Magnets will fall out of the lens and spacer and will had to use feviquik to fix.

Achaa h pr ache se fit ni hota

Ok, but looking at quality, price is very high. Should have been around 1500 rs

Product is good only thing to keep in mind is that be aware to place magnet at right place if intermingled once it will be difficult to fix it up again . Over all quality of lenses are good...

Good package, but defective or very low quality. I waited a long time for delivery, and when unpacking I saw that the magnets were torn off, bad glue was used or the magnets were too strong. I do not recommend buying this, wasted time and money.

I think people aren't understanding how to install these lenses. I know I didn't for the first day or two. There is not a left/right, either lens will work on either side. There are four plastic tabs on the bottom of the lens protector that must be inserted into the headset groove. Although it doesn't look like it with fit, it will click in firmly once it's properly aligned. When I first tried it seems like I had connected it after a couple of clicks but it wasn't. It will take a bit more fussing to connect it properly and once done you're good. Just be sure that the goggles are adjusted all the way out if you wear glasses for maximum room. The product does work nicely.

Garbage. The most important part of this setup are the magnets. You press the rims onto the headset. There are two magnets on the rims, and you would attach the lenses which have two magnets, onto the rims, and they're held in place by their magnets. At least that would be the general idea. Mine? I was missing two magnets. After looking around I realize that the two tiny tiny magnets, that are supposed to be in the rims, are actually attached to the magnets on the lenses. When I tried to remove them phone behold they all fell out. I turned over the other room and lens and they fell out. They're not attached. They're not tight, they're not glued, I don't know what they are. But they aren't, is connected to the pieces they have to be connected to. Attempted to glue them in with gorilla glue but the plastic is too smooth to adhere to the magnet. This company had one thing to do and that was to make sure the magnets were attached. They couldn't do that. Don't bother, find another supplier with the same idea that actually knows what the hell they're doing.

I bought this not for fog control but to filter harmful blue light. The magnetic mount clicks into place well enough if positioned correctly. It didn't seem secure at first but I'm confident it will hold fine unless bumped off. The lenses are of good quality and clarity. Not sure why, but the image is better through these lenses, and I don't think that is the fogging control or tint alone. I can tell it is blocking blue light well. Colors are different when blue light is blocked. These lenses are exactly what I was looking for and are good quality. The attachment seems good enough.

The snap in piece stays in place. The magnetic piece that goes on top of that falls off often. The magnets are not very strong. However, they protect the expensive lenses of the headset, I consider it a minor inconvenience.