Soft Top Reviver - Black (500ml)

Applied easily, thoroughly, and dried quickly - leaving it look excellent. Just follow the instructions and you’ll be golden!

I have used this product in the past to freshen up a convertible top. It applies easily with a wide paint brush. Be sure to prep the area and tape off. It will stain.

Absolutely, this is it! There exists no other substitute! I ordered based on the picture, unaware that the bottle is half a liter. The entire roof of a BMW M6 was covered by that, which was all I needed. I should mention that my top was already in great condition. While there aren't any major dry spots, there is a slight fading. Regardless, I settled on 500 ml and it was sufficient with approximately 5 oz of product remaining for touch-up or safety. The top needs to be properly cleaned and stripped of any repellent or spray wax (which should never be used on a soft top). My method of cleaning involved using 303 top cleaner and a medium-density brush. I utilized the entire bottle of cleaner. To start, rinse the top with a little water. I discovered that the cleaner is more effective on a damp top than a dry one. Saturate the entire top and allow the product to sit for 15 minutes. Use the brush to work the cleaner product into the top. It took me around half an hour to cover every centimeter with some hard work. Rinse the third product until all the cleaner has run off. Use a chamois to dry the additional water, and let the vehicle sit overnight to dry. Next day, 1st go over the top with a handheld lint brush and get as much of the loose fibers left behind or from sitting overnight. 2nd tape off any trim, not necessary to go crazy with coverings ie newspaper, plastic etc... 3rd using a 2/12 inch brush(do yourself a favor and get a better quality stain brush) apply the product working from the center of the top outward. I discovered 2ftx2ft sections made for better application, and accounting of how much product i was using. not going to lye, i was worried about running out of product. * use a step ladder to get better stroke positioning. I found that working in the garage with a shop light worked best, as it allowed me to see actual coverage with each stroke of the brush. I was able to do the entire top with two successful passes and still have about 5oz of product left over for touch up after the 3 hr minimum drying time. i noticed a rich velvet appearance immediately. but that was only because i was methodical with application, easy application when you take your time. 500ml will do two coatings on an 2018 M6, 640, 650 top this includes extra dye on the seams, edges and good deal of saturation overall. i don't recommend applying this outside in the elements as it will be more difficult to see overlap of strokes. A high quality stain or dye brush will work better. And no, you cannot use a foam roller!! the brush will work into the nook and crannies better. use 303 top cleaner, Ive been using this stuff for decades and it is far superior to anything else I've ever used. wait i wouldn't apply a sealer right away. I waited 30 days to do so. Good luck

I think this product works well enough. It did rejuvenate my soft top, although it was in good shape to begin with. Some spots that were discolored did not come out completely. Also, afterwards the top was slightly stiffer and heavier to operate.

I have never been tempted to write an Amazon review before, but upon reading the ones here, I feel like it is in order. The product worked absolutely perfectly for me and my convertible top looks more or less brand new. You have to follow the instructions, though. It is absolutely imperative to wash the top first with a product designed to remove not just dirt but oil, mold, and other contaminates. I did this twice with a power washer and brush with moderately stiff bristles using a product I got for $8 or so at a local car parts store. A couple days later, I washed it again before applying the Renovo. If the surface is not clean and free of contaminates, you are going to get a patchy look because it can't absorb properly. I applied the product with a 2 inch brush overlapping the strokes a little from the center to the side IN SHADE. Again, if you do it in direct sunlight, you will not get good results. When it dried, I did it again and touched up areas that needed it. When it was dried, I treated it with Scotchgard (again from the auto store) and that was it. So . . . takes several hours and you have to apply it methodically and with care (i.e. slowly), but it works great. If you can't make that kind of time or have that kind of patience, take it to a pro or get someone else to do it. However, for a total of about $50 and maybe 4-5 hours of work, my 10 year old car looks new (well, at least the top does.)

Incredible product i was super happy to report i only needed one bottle for my corvette top i did 4 heavy coats

It’s not that good . The black coverage is faded looking.

Worked great on my 911 C4S Cabriolet! I plan to follow up with protector!

Make sure to clean your soft top properly and allow to dry fully before you apply the reviver.

Der 500 ml Softtop Reviver in Schwarz überzeugt sofort: Die Farbe deckt hervorragend, lässt sich einfach auftragen und bringt das Softtop wieder wie neu zum Strahlen. Ich kenne keine bessere Farbe für schwarze Verdecke – sowohl im Finish als auch in der Haltbarkeit top! 💪 💡 Praxis-Tipp: Ideal für alle, die ihrem Cabrio oder Roadster schnell und effektiv ein frisches, gepflegtes Aussehen verpassen möchten. Fazit: ✅ Perfekte Deckkraft & Finish ✅ Einfaches Auftragen ✅ Top Haltbarkeit ✅ Keine bessere Alternative für schwarze Verdecke bekannt Kurz gesagt: Softtop wie neu – absolute Empfehlung für jeden Cabrio-Fan! 🖤🚗

Perfect middel, voldoet aan alle verwachtingen

Bought to recolour a MINI hood that had become discoloured after being parked under trees over the past two or three years - lots of tree sap, bird lime and general yellow/green patches on the black roof. It's worked beautifully and the 500ml bottle is just enough for a single coat. Cleaned first with the Renovo cleaner, the hood was then coated with the Reviver - apply with a 2" paintbrush taking care not to let it run. This stuff is really runny, so a damp cloth to catch spills is vital, but it covers very well and the colour is deep and rich - covered up all the remaining spots on the roof after the cleaner had done its thing. The 500ml bottle is just enough to do a MINI roof but a second coat (second bottle!) made the hood really dark and now it looks like new. The patches are well covered by the Reviver; forget the other stuff available, go straight to Renovo to get the job done properly.

Nice product