IR Repeater Kit, IR Repeater System, IR Remote Control Extender

This IR repeater works great for controlling multiple devices from another room. The signal reaches surprisingly far, and setup was straightforward. Very convenient for keeping entertainment equipment neatly tucked away.

I had been looking for a multi-control IR blaster for some time after completing the build of my dream home theater. I had a wireless IR blaster, but it seemed inconsistent in its responsiveness. The Ensigear appeared to have everything I needed, but I did have to purchase a longer cable to connect the receiver to the module (an inexpensive extension cable). Set-up took less than 5 minutes once I figured out how everything would be arranged in my media closet. The responsiveness is instantaneous-almost faster than if there was no repeater at all! The 6 slots for additional IR sensors ensures that I can expand its use as time goes on (I only need 3 at the current time), but the receiver comes with all of the sensors needed to control 6 separate devices in a media closet. Highly recommended!

Two female 3.5mm Jack ports fell off the circuit board when the male plugs were installed. One input and #4 output port. Unfortunately, trouble shooting other devices took a lot of time and took me off track from the real problem! (This low quality device!) I suggest looking elsewhere. Now I can’t return it. Picture shows device opened up and two loose female Jack ports.

Works as expected. Easy to set up – just plug in power, attach emitters, and place the receiver where your remote can see it. Signal passes through reliably with no delay.Cable length is good for most setups. The LED status light is helpful for confirming power and signal.For the price, it's a solid solution if you need to hide devices in a cabinet or extend remote range. Would recommend.

Works well.

This IR repeater kit is exactly what I was looking for! If you own a Marantz or Denon receiver/processor—or any AV equipment with an "IR Flasher In" 3.5mm port—this is the perfect solution. I'm using it with a Marantz 8805 AVP, and it’s working flawlessly. You’ll also need a male-to-male 3.5mm TRS (or TS) cable. Additionally, if you plan to place the repeater near your receiver, processor, or rack, you might need a TRS 3.5mm extension cable (male to female) for flexibility. I did not need any of the IR blasters this IR repeater comes with, since my unit has an IR input jack. I recommend this product for its reliability and ease of use.

I bought this kit after trying a cheaper kit that burned out on the second use. This one I am very happy with. Comes with everything you need in the box. The little converter box is small enough to be mounted anywhere. It can be powered by either the included "wall wort" power cord, or can be hardwired into a 12 volt power like you would find in an RV or camper. The receiver is well designed and can be mounted vertically or horizontal, and has a little raceway built in for the cord so it will lay flat against whatever you adhere it to. There is an LED in the receiver too so you can tell when it is receiving commands from your remote. There's no constant power light either, which for me is ok. Theres no obnoxious light that is on when you're trying to sleep. The cords are nice and small in diameter and don't take up much room in a raceway, but yet long enough to reach whatever you need to control. The adhesive pads are nice and strong, but feel like they can be removed without damaging the surface. I have not tried to remove anything yet however, so this is speculative. Happy with the purchase and recommend this for any component that is stored in a cabinet and controlled via IR, whether that is in a camper, or your home entertainment center.

Unusable due to short distance from remote to receiver- about 4 feet.