32 Channel 96A RGBW DMX 512 LED Decoder Controller DMX Dimmer DC5-24V RGBW RGB LED Light 8 Bit/16 Bit

This DMX decoder does exactly what it says on the tin (literally as its screen printed case is labelled well and built very sturdily)!I've had it a little while now so have had a good chance to put it through its paces. It accepts any DMX signal I can throw at it (USB to DMX dongle, Zero 88 Console and E1.31/sACN to DMX interface, along with a few testers for good measure)!Configuring the decoder is very simple, using the three buttons that are under the LED display.As it's possible to drive high current loads through the decoder, four supply inputs are provided. These can be driven from a single high-current power supply or separate ones as necessary. Each input powers two groups of four outputs however it should be noted that the ground (zero volt) inputs are commoned inside the decoder. Different voltage supplies could even be used if you need to power a 5V, 12V and 24V LED strips simultaneously, for example. The decoder is powered from the power supply inputs and seems to require around 90mA at 12V and 40mA at 24V.The outputs (on very good removeable connector blocks) are arranged for easy connection of RGBW LED strips although can easily be used for any other purpose (within reason)! The outputs can be configured in one, two, three or four channel modes with the decoder requiring 8, 16, 24 or 32 DMX channels.This is one of the few devices that I've found which is switchable between 8 and 16-bit modes. 16-bit mode uses two DMX channels per output (16, 32, 48 or 64 depending upon the mode). Although seemingly wasteful of DMX addresses, this gives much, much smoother dimming of each output. Very slow fades are therefore possible with no noticeable stepping between levels, naturally the software or console will need to support 16-bit dimming. The PWM (Pulse Width Modulation) of the outputs is around 490Hz so there's no flickering evident as can happen with slower PWM.The built-in programs are good for testing that everything is connected and working correctly but a bit too limited for anything other than testing.All in all this is a very well built device and performs exactly as the instructions say it should. Highly recommended if you need high-powered dimming with options to control different voltage LED strips and a 16-bit mode.

These lighting controllers are very easy to set up and use. I like that you can change the bit rate between 8 and 16 and also use 5 to 24volt dc supplies, which is great for 12 or 24v LED strip.All outputs are on 5 way plugs and you have the choice of DMX jack or three wire connection for the DMX control signal.Good sturdy metal case with holed flanges to screw down.Have used over 10 of them with no reliability issues.

Instructions are rubbish, Cant find any help on this product. After wasting my time and money I now cant return it.

Generally great, dimming seems to judder a bit compared to other models I’ve used.

Works well. The only thing I don’t like is that it reverts to being ‘on’ all the time with no DMX signal. Dims okay at the low end for the price point.