BILITOOLS 10" 2 Jaw Gear Puller, Bearing & Pulley Removal Tool, Internal External Reversible for Flywheel, Gears & Pulleys

Has worked great so far removing rusted bearings from shafts at work.

Arrived quickly and is very sturdy. The fingers are a little too large to get into the holes on the hub so I really could not use it for my project. I am sure it will work well for other jobs I may have.

Very sturdy. Oil the threads and you'll have no trouble

Great Quality Tool — Just Make Sure It's the Right Size for Your Job I ordered the 10" BILITOOLS gear puller to remove the rear brake drum on my 2014 Hyundai Accent. Unfortunately, it ended up being just a little too small for the job — it couldn’t quite reach or grip well enough to pull the drum off. That said, I was actually impressed with the overall build quality. The jaws feel solid, the threads turn smoothly, and the whole thing has a sturdy, well-made feel to it. It really seems like it could handle a lot of force without any issues. While it didn’t quite fit my specific use case, I can absolutely see it being perfect for smaller tasks — like pulling pulleys or bearings. Just a heads-up: if you're planning to use it for brake work on larger drums, make sure to double-check your measurements beforehand. Hope this helps someone else find the right size tool for their project!

It seems a decent quality puller. The maximum depth of pull is a little less than 10", to allow for the hooks. The parting lines on the cross-bar casting finish have been smoothed. The breadth of pull is wide even for exterior pulls. There are two spring-loaded tabs to retain the hooks. I use this to pull pressed bearings from large truck spindles in drum brakes. With a good puller it is uneventful. But this application did not stress the strength of the screw, so I cannot evaluate how well it would withstand a hard pull job. I can say there are no graduations on the crossbar, nor notches or other means to ensure the hooks are equally spaced from the screw. The job I use this for doesn't need them. But if you had a harder pull, with more force on the screw, you'd need some way to ensure it was perfectly aligned. But for the low price point this is hard to beat.

Works good with some 3D printed adapters

really tought material, well machined. Be aware the "max spread external" is the biggest rim/gear diameter it will fit! I read the table the wrong way. Had a 9" diameter wheel rim and this10" does not fit it....i needed the 12" next size up.

Did NOT pull out rear windshield wiper assembly from screw. It was difficult to get it to seat properly, and ultimately damaged the end of the screw. Bummer.

Excelente herramienta muchas gracias Amazon por su atención y servicio