Speaker Wall Mount, Holds Up to 30lbs, Swivel and Tilt, 2 Packs

Bought these to hang my sony surround speakers up on the wall and the are easy to hang and are heavy duty well made can move them upward or downward and sideways for what ever fits your needs also look nice has well .

Good quality an all metal!!

This mount is strong. You can swivel the speaker with fine adjustments. But for tilting can only be adjusted in 15 degree increments, so be aware. I wanted to angle the speaker down at about 5 degrees, but couldn't, and 15 degrees was way too much. I had to settle for 0 degrees, which worked when I ended up lowering the speakers. The supplied mounting hardware is for concrete/brick, so I imaging it's useless for most people. The two mounting holes are probably good if mounting into a stud, but I wish there were four for mounting into drywall. I was using two 46lbs rated drywall anchors, but the top one started pulling out, so I had to buy an extra strong anchor. Keeping in mind those limitations, I would buy this product again.

Easy to install and adjust. I installed some Polk t-15 speakers. They weigh just a little over eight pounds and these metal brackets worked perfectly.

These worked perfect for my rear speakers in my theater room.

Well designed and sturdy speaker mounts. They have multiple options for mounting your speakers. As others have mentioned, the supplied anchors for sheetrock were not sufficient to hold my 14 pound speakers. I recommend you get better anchors from a hardware store or mount to wall studs.

These are really nicely made and gives you a lot of confidence that they will hold up well. They give a good amount of articulation, up/down, left/right. I used these on my Polk Audio T15 bookshelf speakers and used the keyhole on the speaker to mount it to the bracket. I did end up buying some different screws for my particular anchors that I wanted to use for my drywall, as I prefer the self drilling drywall anchors (Twist and Lock). All in all a very nice product.

I really like the wall mounts for my speakers. They are very adaptable so I don't have to just aim them one direction but can turn them left/right, up/down for better clarity of sound. That being said, the directions could have been better. Firstly, I needed a 10mm drill bit, which was a problem since all my bits are in fractions of inches, like 5/8. I found a bit that was actually just a tiny bit smaller than 10mm and used it. The problems got worse when I went to use the provided wall anchors for the screws. They fell into the wall because the hole I made was slightly too big, even tho it was smaller than 10mm! Long story short, use a bit that is at most 8mm for those holes so that the anchors fit in the hole good and snug!

Good quality.

Utiliser avec haut-parleur klipsch fais très bien le travail matériaux robuste c'est un bon achat je recommande !

Soportes de muy buena calidad y muy prácticos.

Very high quality product. I thoughly recommend

Speaker mounts are very strong, thick metal. Very well made. Came with all the screws and bolts necessary. Delivery was prompt...ordered Monday arrived Wednesday.