Lifegard Aquatics 1-Inch Bulkhead Fitting Kit

Great quality and perfect fit into PVC. I won't be using the elbow piece for my setup but it seems to work ok. The tolerance between the elbow and the strainer is a bit loose for a horizontal setup (the 1/2" bulkhead kit that I also bought was perfectly fine), but as long as you have it vertical it would be fine. The strainer fits fine right into the bulkhead, which is how I will be using it. Half the price of many other pieces online; would buy again.

Worked great for an additional drain to the pond for me. Easy to use.

I used this to add a drain to my 100Gallon rubbermaid pond. Put it right near the top just below the outside lib and I can easily adjust the outflow height with the 90 degree elbow to adjust when it will drain. Perfect!

I like these! Have used 4 in my fish room so far. Will buy more when amazon lowers price back to a fair price I like them at under $7 not above $11. I wish amazon would quit the price games! Would be nice to go on amazon and buy what i want and not have to wait for prices to return tto where it should be. i am waiting for the price to drop to buy 2 more.

I received the product on time and everything worked out great. I can tell the quality of material is high and the parts fit together perfectly, so installation was easy.

Solid build, well finished. Threads are solid and there is little chance of stripping these out unless you really try hard! Used for an outdoor aquarium setup and work perfectly for my purposes. Bought 2 sizes to cover the bases. Kept this for future use

Good Quality Plastic used, contained everything it was suppose to, however measurements are not accurate. Fitting is a 1 3/8 ID and 1 5/8 OD causing a 1 3/4 hole needed. at widest point it is 2 1/2 inches. Be prepared to cut a larger hole like i had to.

I was looking for bulkheads forever, but didn't know what they were called. If you need a water tight seal going through another object this is what you need (you can find them without the extra fittings also). I used this to add an above ground tank to an in ground pond. The filter pushes water from the pond to the tank through the bulkhead. Use a 1 and 3/4 inch drill bit to cut your hole. One strong recommendation is to get a check valve if your using this on the suction side so water can't drain back. These fitting are solidly made and work great.