12V Reverse Polarity Switch Momentary Power Jack Rocker Switch DC Motor Control DPDT 4 Pin(ON)-Off-(ON) 20A 12 Volt DC RV Switch with Wires

This was quick and easy to replace the failed one on my R-Pod 202. No issues whatsoever.

That fixed my problem with my electric jack. I recommend getting it before you go buy a new jack.

This 4-pin replacement switch was exactly what we needed for our RV jack that had been acting up. It fit perfectly and worked like a charm. The installation was a breeze—took less than 10 minutes, even for someone with minimal experience. Our RV jack is back to functioning smoothly, and we couldn’t be happier with the results. Highly recommend this switch for anyone dealing with similar issues!

My original switch wires were soldered to the terminals. That original wire is at least 12gauge in thickness. That makes sense, as the trailer jack draws A LOT of amps. (The inline fuse is 30A, which blows immediately when the jack hits the max extension!) That said, I was surprised at how small (probably16 gauge) the included wire pigtails were. I didn't think a regular crimp would be adequate for splicing the wires, so I soldered the wires first and covered the splice with a heat shrink fitting (Solder seal wire connector) The switch fit perfectly, and works great. I hope the pigtails are adequate for the amperage load. I'll open up the trailer jack panel and check down the road.Footnote: Several people commented, in their reviews, that the switch works backwards. This switch will REVERSE POLARITY. One direction makes the jack go UP, and the other direction makes it go DOWN. If they are backwards in relation to their labels, switch the wires that go to your motor! ...basic electricity.

Worked perfectly for the bed switch on my electric tongue jack on a Casita travel trailer. You just have to ignore the wording or put your own words on top of the label.

I recently replaced the stock button on my Rpod 202 trailer jack switch with the Weideer 12V Reverse Polarity Switch, and it has been a great upgrade. The stock button had started to fail, especially when raising the jack. The Weideer switch fixed this issue perfectly.Installation was straightforward and the switch fit seamlessly. The quality of the Weideer switch appears to be superior to the original, feeling more robust and durable. Only time will tell how well it holds up, but so far, it’s performing better than the stock button.

Worked great as a replacement on my lippert tongue jack. My lippert switch failed in 8 months, manufacture warranty is garbage. They wanted to sell me new switch for $46.00, this swith fit perfectly, took me 7 minutes to replace. At a fraction the price. Highly recommend!!!!

Once after several attempts was able to run wires correctly.