SP18-716 Zinc-Plated Asphalt Anchor (7/8" x 12") - with 1.25" Hex Bolt & 1" Washer - Chemical Anchors - for Installation of Sheds, Carports, Bike Racks, & More - 2500 lb Pull Rated - 6 PK

Easy to install

I buy these to anchor wheelchair ramps to the ground. They work well for asphalt. I usually end up cutting them in half so I don't need such a deep hole. They hold well once the epoxy sets up.

These worked as advertised. I don't know about pull strength but I assume it will be adequate to hold down my fabric car shelter. I will say all 8 I put in didn't seem to have the same strength potential based on how the asphalt and substrate was at that spot. For example, the grout seemed to run away down the hole in some cases, and not accept too much in others. As a rule I'd say use as many anchors as you can to spread the load and don't assume 1500 lbs each. That's probably an ideal case number. Also don't put them closer to each other or to the edge of a pad because asphalt is weak. Guessing, I'd say no closer than 3" hole edge to edge, and more than that is safer.The great thing about this system is it's pretty easy to install, and when done it just adds a flush flange to your blacktop. Nothing in the way if you decide to remove the structure in the future.

I used all 6 to anchor down a carport. I cemented in well and seems solid.

I used this product to bolt a sign post base to asphalt. Very simple to use and has been holding well for several weeks. I expect this to last as long as the asphalt.

I used 8 of these anchors and they seem to work well. My advice, though, is to wait a full day after setting them in the grout. If you use them sonner the anchors will begin to pull out

Everything was provided to make the job go smoothly. Anchoring in asphalt couldn't be easier with this kit.

Great product 👏🏼👏🏼👏🏼

As advertised. Used for anchoring my portable garage to the asphalt, did not disappoint.