3157 Gasket Making Material

Worked perfectly as intended. I used my wife’s cricut to cut the carb gaskets for my 1979 MGB. It is a little thicker than the original gasket but works perfectly. The material is super durable and flexible. The sheet was large enough to cut a ton of gaskets and will probably use it to make more gaskets in the future. Great value for the money.

Solid material. Worked great for my fuel pump.

Fel-Pro is a trusted brand, so I went with this material for installing my manual 4x4 hubs. It is obviously far better than the paper gaskets included in my hub kit and will protect them from the elements. Salt and dirt are huge issues on the roads here, so this added a piece of mind that my investment will be protected.

Works for what I needed

Excellent gasket material, Fel-Pro is an established gasket maker and they make a great product and I've used their gaskets for years. Had to get this roll to make a carburetor body gasket for a 1963 35 Massey Ferguson. Cleaned the carburetor out, put it back together and been using it with no leaks.

Good gasket material enough for many projects. It's a fair price compared to each gasket bought separately.

Always helpful to have some gasket making material around instead of paying for a pre-cut replacement (and putting your project on hold while you wait for it to arrive). I’ve always had good luck with this Fel-Pro gasket material.

I was installing an old pump on my air compressor's tank so I figured I would open it up and clean up the bore and inspect piston\rings. To my surprise the "head" gasket set was over $50 (two gaskets). This fit the bill perfectly. It did take a bit of time to trace the outline of the head and valve plate (the old gasket was destroyed upon removal) but I am very happy with how it turned out. I saved over $40, have extra material left over for more gaskets and the pump works great. I used a very sharp blade as well as some good scissors. I had better results with the scissors. For the bolt holes I tried a drill bit but caused too much fraying. Then I tried a standard single hole punch and it worked much better. This definitely beats waiting a week for a gasket that can cost as much as $25\pop.

Great value high quality made in USA

Primero hice el molde de la junta y posteriormente lo calque al material para juntas, es facil de cortar, utilice una navaja para cortes precisos. Ya coloque la junta y hasta ahorita va sin fugas.

Good quality name brand product. Pleased

I made an extremely intricate gasket for an outboard, worked perfectly,I will only be using this brand of gasket maker, I have tried other brands bought on Amazon and they're absolute garbage ,this one did not leak ,absolutely perfect.

Buen producto