GASPRO Glass Wind Guard for Fire Pit Table

Arrived without damage, well packed, easy to assemble only took 10 mins, you might need to open the hinges just a little with screwdrivers so the glass slides in easily. Looks great and really does do the job as a wind guard, we can now use the fire pit on a windy night! ... very happy

Easy to assemble & works great on propane fire pit; very heavy duty tempered glass

I purchased this product a couple of months ago and this is the first time I was able to use it. I love how it looks with the flame. In the photo I have the flame at the lowest setting, and because it blocks the wind, the flame is nice and high!!!! So happy I finally bought this!!!

If you are reading this then I don't need to tell you what this does right? So let's get right to it then. The tempered glass panels are thick and free of distortions. I'd say they're about 7mm thick. This thing isn't a light weight and should hold up well outdoors. The size fit our fire pit perfectly with about an inch gap all the way around the gas tray. There are rubber feet to raise the glass about a quarter of an inch thus allowing air to feed the flames. Since glass and metal brackets don't bend, assembly can be a little tricky especially if some of the sand casted brackets a slightly out of spec. Make sure each bracket is facing the correct way, as four have threading for the feet and four do not. My recommendation is to finger tighten each screw leaving some wiggle room to get the last glass panel on. I had to use a little WD-40 to get it to slip onto place. Once it's all together, then I proceeded to tighten snugly no over do it, the screws. Install the feet and you are ready to go.

Made my own concrete table fire pit and needed a wind block. This was the perfet size and does great with blocking wind.