Pattern Flush Trim Router Bits 1/4 Shank, Bottom Bearing Pattern Router bit Set, 1/4 Flush Trim Cut Router Bits, Handy, Durable & Sharp for Home DIY

They work fine!

Broke one on first use. 100% user error. Had to buy a whole new set. I wish they sold them individually or as a set. Have used them a few time since and they work great so far.

They are not bad for the money, BUT, my first cut with these was on a small piece of maple, routing out a 3" circle. In 30 seconds the bit broke on the bottom edge. I just used a longer one and adjusted the router to finish, but they should not break cutting 1/4" into maple. Amazon/seller replaced the set, but common man!

So far working great, bits are sharp and seem to be holding up good. use them regularly.

I decided to install my first pocket door and one thing I quickly discovered after tearing into the wall and buying a slab door was the need to make some jigs and rout for the handle and pull hardware. Despite my collection of over 36 router bits, a number of which I have never used, I didn't have any of these - flush bits with a guide wheel at the shank instead of the tip. This turns out a perfect collection for pocket door hardware, and the assorted sizes - I thought them a little overkill - turned out to be a godsend as I used three or them for this one small project. I did a couple of test cuts on scrap and it's a good thing I did, just to get used to using these for two depths (shallow on the outside and deep on the inside). To my surprise, I found it better to cut the smaller, deeper cuts first so I could get a better site on clamping my jig for the next wider, shallow cuts. These came sharp sharp, each in a nice and secure little clear case. Deep shanks for good purchase. No idea how long they will last but for this first project, much better suited for my task than I realized when placing the order. Very satisfied!

Great quality! Perfect for intricate work.

These bits are very low quality, blade broke off on the second cut on two of the four, haven’t used the other two . I will be sending back.

Not sure why I expected the router bits to come in a kit. The bits were packaged in a small cardboard box with the extra parts in a flimsy plastic bag where the bottom of the bag had split open. Box included all four bits in sturdy plastic tubes with sealable caps to protect the cutting edges of the bits. The flimsy plastic bag was supposed to contain two extra bearing, two extra spacers, and an allen wrench. Also there were 5 little bits of metal for which I am uncertain of why they were included. I have used the router bits for a couple of projects and so far they seem to keep their edge and make clean cuts.

I needed to install an under mount sink on a butcher block countertop. And to finish the cut Perfect, I made a jig, and the Cut could not have been a cleaner cut. Really finished the project off perfect.