3Pcs Decapping Pin

The ZOEKIM 3Pcs Decapping Pin set is a solid replacement for the Lee 90783/90292 Universal Decap Die. They fit properly, install easily, and function exactly as expected. I’ve been using them primarily for 9mm, and they decap smoothly without any issues.

Unfortunately, I have gone through a lot of these. The price of reloading starts to add up when the tip gets bent and broken. I bought these specifically because it came in a three pack and they were inexpensive compared to the OEM part. There is nothing that disrupts a batch like breaking your one and only decapping rod. Then waiting two weeks for it to be delivered. So far, so good.

Ordered a 3 pack. Very first shell I tried to deprime bent the rod like it was a piece of plastic. DO NOT USE THESE ON CRIMPED BRASS. perhaps it works okay for regular brass but idk cuz I use my resizing dies for that. Just a heads up, if you are trying to deprime crimped pockets then I would go for the mighty armory decapping die.

They are a little thicker than the lee ones. Don't know if that is a bad thing maybe more sturdy.

The coating makes them a very tight fit into the tensioning nut. Good for use on normal reloads. Bend relatively easy if using on crimped primers or very dirty/aged range brass.

Worked and fit perfectly in my lee Universal. They actually were slightly tighter fitting than original.

I put 25-30k rounds on the original pin before it bent. I bent all 3 of these in less than 4k. Might be good for an emergency spare but not for running a lot of rounds.

Works very well. Absolutely no breaking of pins whatsoever when properly used. If you break a pin it is 100% that it wasn’t lined up correctly.

Works great. Fits all lee dies (or at least the ones I have). Cheaper then buying from cabelas once you consider shipping and quite solid. If you’re burning through these it’s worth it.

I damaged my Lee Loader decapper on its first outing. I forgot to remove the cap from under the decapping cartridge holder and bent the pin (which snapped off as I straightened it). I ordered these to replace it and they have worked fine, more resilient than the Lee Loader original tool. I suspect I will need three, it looks as if decapping is a stressful exercise :-)

These decapping pins are undersized and keep slipping in the decapper clamp unless the decapper clamp is tightened down with extreme force. Factory original parts are 0.205" in diameter and these are 0.199" in diameter. That may not seem like much but it makes a big difference. These decapping pins have a tapered point which enlarges the flash hole if it isn't adjusted just right. Too long and it stretches the flash hole, too short and the primer doesn't drop free. Overall they aren't worth the money. I should have bought the proper replacement part from Lee Precision.