GS Power Engine Hood Hinge Ditch Brackets for mounting Auxiliary Off-Road LED Pod Work Light. Fit Between Hood & Cowl Panel at Windshield Base. Compatible with 2016-2020 3rd Gen Toyota Tacoma

Great product. Super affordable way to mount some ditch lights. I’ve had them for over a year and they don’t rattle on and off road

Installed on 1st Gen Tundra. Fit well with good clearance at windshield. Hood does sit high but could be lessened by filing the bolt holes or relieving the wiper cowling, I did neither. Installation is easy, just remove lower hinge bolt, install bracket, install and snug bolt, remove upper bolt, rotate bracket to align with hole, install bolt, tighten both. Repeat on second hinge. Took me less than 10 minutes. Product seems beefy with good finish and paint.

Worked a treat and bolted right up to my Lexus GX470. Sweet deal for the price. I don’t think the finish will last years, but for the price it’s almost worth replacing every 3+ years.

Almost perfect fit on a 1st generation Toyota Sequoia (2001-2007). The slotted holes are slightly too short in distance and will need to be grinded down in order for the screws to be seated properly. I had to grind down the rearward hole (hole closest to the windshield) to move the bracket forward towards the front of the car. This is to ensure that the bracket doesn't hit the windshield when the hood is opened. Also, the windshield wiper cowl will need some modification for the hood to sit flush with the fender. It's not necessary but if you don't then the rear of the hood will sit a little higher than normal. More work than I expected but this wasn't intended for my vehicle. For the value it's not too bad at all! The price is great, but the extra work needed made it fall short of perfect. Minus a star because it wasn't as solid with the light I had on it. It was a bit flimsy and shook a lot on bumpy roads. A solid 4.8 stars in my book.

Great ditch light bracket. Designed very well and sturdy to hold lights.

Worked out great for my Gen 3 Tacoma

Easy to install. No mods. Only tool needed is 12mm socket. THESE GO BETWEEN BOLTS AND HINGE! Not between hood and hinge. If you install that way the hood will sit proud and latch awkwardly. To install, remove bolt closest to front bumper, attach mount with other hole offset, replace/tighten that bolt, remove rear bolt, swing mount over into place, replace bolt and tighten. Doing it this way keeps the hood from shifting around so you don’t have to readjust it in relation to latch. SEE PICS

Doesn’t for my ‘03 tundra. Spend you money somewhere else. These are junk.