Automatically Steps Counter Compatible for Pok emon Go Cellphone Pedometer (Width Under 3.4 inches) Electric Version Non-Magnetic, Mute Stainless Steel Bearings Quick Steps Earning- White

I bought this type because the one I have swings front to back and would not work with my new Motorola phone. This one goes side to side and works great! This design is so much easier to use. All I do is turn on adventure sync and close out of Pokemon Go. Then I put the phone to sleep and slide it in the Counter (no rubber bands or bearings to line up). After about an hour my 12K egg has hatched! BTW I am disabled and it is hard for me to get around.

I thought "For $20, why not try it?" and I'm happy that I did.Pros: It's dead-silent once it's configured properly, expands for larger phones, and runs for days at a time without needing to restart the swinging.Cons: I haven't found a way to charge the phones (that's right two at once) while they are swinging. Also the instructions aren't super clear so it's frustrating to get started. The plastic is a bit flimsy but I'm fairly certain this will hold up for a long time.PoGo is finicky about counting steps, but that's always the case so I can't count that against this product. When it does work you can rack up buddy distance, research distance, weekly distance, and incubator distance. Here's my setup that has been working:1. Turn on GPS (It may work with it off, but my best days are when it's enabled) Wi-Fi or cell data will be needed to use adventure sync, but you can manage without it.2. Close PoGo then download and open Google Fit. Set your height to the tallest setting. Someone said you need to use the same Google account for Fit and PoGo but idk.3. Start a treadmill workout (set units to km for easier tracking) You can create a home screen widget to quickly start workouts.4. If you're using multiple phones like me, strap them together with a hair tie or something. Keep the heaviest phone on the inside or the stand may topple over. (I use a pixel 2 XL and a tiny Samsung phone. Three phones may not work bc the stand will tip over if you nudge it with just two in there)5. Phones should go in the holder upside down for better step counts. There is an extender included in the box that gives the phone a better angle which can improve your step count as well.6. To position the arm, start with the holder and arm straight down, then nudge it left for heavier phones and right for lighter ones. You shouldn't need to go more than 20⁰ to either side. While swinging, the power light will flicker if the lever is activating the device correctly.7.Leave it alone for up to 30 minutes to check if it comes to a stop, then reconfigure the arm if necessary. If it lasts that long you're good to leave it for 12+ hours.8. If the arm is scraping or clicking you can adjust the angle of the arm with the upper knob which is super clever. The fine-tuning requires patience, but I promise it will pay off.8. When you're ready to sync your steps, end the workout and wait for the Google Fit summary to update on the main page. Open PoGo and reap the rewards. The swinging does work sporadically with Adventure Sync, but I have better luck with the manual syncs. If you are swinging spare phones and playing on your main one simultaneously, the sync doesn't always work. Try to minimize time spent in the app on your main phone to acquire more steps, and only open it to switch buddies or fill incubators.I used Tasker with AutoInput to set up a macro that manually syncs the steps every hour and fills my incubators for me before starting a new workout. It was a bit technical and time consuming, but you could do something similar with enough effort!I hope this helped you out! If you're lost with any of this, Google and Reddit are your friends.

I bought this product 2 months ago and it was working great for some time, I would put my phone in it when I went to bed and would get around 40km by the time I woke up. It was great for pokemon.But slowly it started not being as good and wouldn't swing as much with my phone in it. When I first got it I could set my phone in it with the case and it would go all night, then it would stop after an hour, I put my phone on it with the case and it would work fine, but now its just gotten so much worse that it barely works for more than a minute before fully stopping. I tried using the extension piece so the phone was at a slight angle on the arm (this is actually suggested if steps aren't being counted on the phone, but I wanted to try it just to say I tried everything.) I changed the position of the lever to different angles to have wider or shallower swings and they were all the same, they would swing normally for about 30 seconds, then the swings would gradually get shorter and shorter until it wouldn't swing anymore.It's like it gradually can't handle the weight of a phone anymore, because when the phone stops swinging if I take it off the arm and just tap the arm it will start swinging normally and go on forever.If you order this product I say use it until right before the return window ends then return it or get a replacement, then you don't have to worry about it slowly becoming obsolete and not being able to get your money back

Great walker. Works great with my Pixel 6 Pro. Make sure your phone is able to detect steps. You can do this by installing Google Fit and then turn off GPS and walk around for a while and see if it recorded steps.. Or you can just hold it in your arms and swing them like you're walking for a minute. Then check the Google Fit app;s step count and see if it recorded anything. You can adjust the height of the swing easily by adjusting the wire bar. Move it closer or further away from the center support and that will adjust the height/speed of the swing. Remember to use the black clip that comes with the swinger. It just clips on the two prongs of the lower support, but the angle makes a difference. Also remember to raise it fully to the right side then release it to start the swinging. It may hit the far side with a small "click" but will then settle down to a nice steady cadence.I did have an issue with the power switch but I emailed the company and they quickly responded with several suggestions and then provided me with a replacement unit. The original unit worked flawlessly until the switch acted up and it may have just been a defective switch. The new unit is working great. If you want you can always just unplug the USB cable from your power source instead of using the switch but you'll likely not have to do that. I have mine plugged into my computer's USB port and that provides enough power to run it.Great Auto Walker for Pokemon Go. Worth the money as it's not flimsy , holds the phone securely and works great.

It may take a bit to get the phone situated correctly on the device, but it works perfect after it is set up properly!