Rok Hardware 35mm Hinge Boring Forstner Drill Bit, Blue ROKBB35BLUE

I needed to install some Blum hidden hinges so I needed this size bit for the holes. It worked perfectly. The holes were smooth and it was easy to use. I've seen a few reviews that complained the holes were rough or the bit wandered. I didn't have that problem at all. I drilled the holes into Maple cabinet doors and the holes were perfect. Also, if you punch a small starter hole with an awl or a nail to put the point of the bit in it will stay straight and not wander. I don't own a drill press so I used a hand held drill and had not problem. I haven't used it a lot so I can't comment on how long it will stay sharp but at 8 bucks I don't see how you can go wrong.

This bit does exactly what it should and it even works well with a handheld cordless drill. I needed to put some concealed hinges in oak cabinet doors, and this made very quick work of creating the precise pockets in the hardwood. It would have been a breeze with a drill press or using it as a router bit, but I did the job with a cordless drill and this bit had to be good to allow me to get away with that. There are other bits out there that cost a lot more or a little less, but this did a great job and was worth the price I paid. Two thumbs up based on performance and price.

Nice bit, works great.

Used to bore 15 new kitchen cabinet door hinge pairs (30 holes) on a drill press. Worked without issues. Saw the inexpensive price as a one project use tool but I believe it continues to remain sharp enough for future uses.

Had just a few hinges pockets to drill, rather than use a spade bit I had (expected a rough cut), this bit was perfect. The depth of the cut is easy to measure, as the height of the bit is designed to fit flush once you're at the correct depth. No need to measure. Pilot in the center is short, no need to worry about poking through the other side. Cutting melamine, with a hand drill, the secret is to start slowly with light pressure and let the cutter get through the brittle surface, this prevents chipping (figured this out he hard way). Even the sloppiest cut is noticeable only by me. Of course, they're on the back side, how often do you really look that closely? Highly recommended for a DIY'er.

I used this to bore a hole into pine and oak when building some music boxes. It is very sharp and did a great job. If you are looking to use this on a limited basis, meaning your frequency of use matches that of the home hobbyist, then this is a good affordable choice.

works great

It got the job done, but the bore was not super clean. But $5, i got my money's worth.