Downcut Spiral Router Bits

Work as advertised, got the job done i needed to. Great quality, the right size as advertised, sharp, and clean. Will be buying again.

A friend told me about these. I've been a bit hesitant to buy carving burs from anywhere other than a wood carvers retailer after being burnt a few times. But these are different. A total home run. They're super sharp and perform better than expected. What's even better is they're super inexpensive. If you do carving with a rotary tool you'll definitely want to give these a try

Good cutters for the price. I use them on my Shapeoko, and they do good work. No coating, so they can get gummed up easier than an Amana might, but they're also a fraction of the price.

I don't often say this about a product but these side cutting bits are the cats ass. Just one bit cut out 4 large penetrations through 28 Guage galvanized sheet metal and finished shaping 3/4 inch pressure treated plywood to fit my RV storage doors and that one bit is still ready to go. Talk about the right tool for the job!!!

12v fan fast

I run a CNC sign shop and we use these as our roughing bits in all of our smaller router tables. They work great, and for the price the life i get out of them is amazing.

I needed a bigger bit for the rough pass on my 3018 CNC machine. For reference, I am milling wood, specifically MDF, Oak & Plywood. The detail pass works great with a smaller bit, but getting the excess out takes forever with it. I wanted a down-cut end mill to have a good flat bottom. These bits seem to work great, I have no issues at all. I have only had to use one so far and it has cut out several pieces with no problems. I use the rule of thumb to only cut 1/2 the diameter of the bit for each depth pass and that seems to work great! I would definitely buy these again and would recommend them to fellow woodworkers looking for a similar solution.

They are cheap.. was leaving a good clean cut while it lasted... 1st use right out of pack one broke during a carve into some plywood... could just me using wrong speed of something but it seemed good for most of the cut... trying another to see if it cuts the rest of the job... good thing they came in a 5 pack