Dasen 42" LED Light Bar Mounting Brackets Compatible with Polaris General 2016-2026, Straight/Curved Light Upper Roof Windshield Roll Cage Mount Brackets

All good

Installed a 42” curved light bar under the roof visor with these brackets. I suggest using a nut on the back of the visor bolts to securely set the bar into place

Going to modify the brackets to fit correctly, better than spending $80+ on the correct measured brackets.Description CLEARLY states 41.5" distance between the mounts on a Polaris General. Closer to 43" when you put then in place. I searched and found a curved LED light bar that measured 41.5" at the brackets... go to put them on the General tonight, and realize the discrepancy. I could have bought a bunch of other lights that were closer to 43" IF I knew the measurement was that far off.I will get it to work, but just want everyone else to know the description is wrong... If you buy these brackets, I would HIGHLY recommend to not purchase a LED Light bar until AFTER you get these brackets and measure on your General first. I purchased everything at the same time.As far as the brackets themselves? Outside the measurement being wrong they look fine and should do the job once I spend the time to adjust them.

product worked perfectly. Had to put the left on the right and the right on the left but they are great.

Completely junk! Do not buy! First it does not even come close to fitting the light bar. So I bent it in to fit. Once it’s on I drive and it shakes so bad it’s about to fall off. Flimsy junk. Stay away!

I purchased for my 2020 General XP4 with Polaris flip up glass windshield. The brackets work fine and were easy to install. The only issue is when the windshield is in the fully open position it rubs the brackets.

They fit my 42” curved nilight perfectly on my 2020 General 1000

Plan on using for ice fishing to see better at night