3D Printer Glue Stick for Hot Bed Adhesion Solution(4 Pack) | For PLA ABS PETG PC TPU HIPS Filament, Glass, PEI, Buildtak, Kapton, 3D Printing Accessories

Works great. Can make the prints a little harder to remove from the bed but overall, great stuff.

Good stuff

Great

I didn't pay attention to the fine print. I tried Magigoo, and it works well but is expensive. So I saw this and on a whim bought it. It *DOES* work very well. Make sure you remove the parts before your bed cools down completely, cuz it does bond! But, it's a general purpose "stick glue". Elmers is much less expensive and works the same. But I'm happy with it.

Careful using this. Using too much will make it extremely hard to get your print off. Also does leave some stick residue on the bottom of a print that will need go be sanded off but works great

Sticks a little, but not strong enough to hold detailed ABS prints. Lifting in several spots already - I’ll have to go back to the more expensive stuff. Did a decent job on some PLA grids I printed.

I started using these glue sticks after I started to have trouble getting my prints to stick to the build plate. It's very easy to clean off of any type of build plate also. Just hot water and soap and it comes right off with minimal scrubbing. I have kept these glue stick in stock ever since I started using them. It's a must have if you 3d print in my opinion.

I've read about all kinds of binding agents (glue, hair spray, tape, rain dance, etc.) but for my lack of experience using these has helped me create some great prints. I still have a lot to learn and need to work on my temps (I'm getting good adhesion, but a bit of flow) so may be a temp issue. Not sure if I can use a name brand white glue stick, but for the price, these fit the bill. Most of my reviews are higher rated because I base what I purchase off of what I need, price, and quality, and not that I purchased the wrong item, or didn't read. I didn't have to reach out to the seller or the vendor, but I would not hesitate to purchase this product again, from either.

これは密着しづらいなというのが慣れてくると分かってくるのでこれはヤバそうだなと思うものを印刷する際に使っています 渡しの印刷物の場合はべっとり塗らなくても大体の感じで塗りつければちゃんと機能してくれるようです 使用後は水洗いしたりウエットティッシュで拭いて再度塗布したりまちまちですが便利に使えています

Lo intenté con varias impresiones pero estas se sueltan como si no tuviera ningún pegamento

As my experience it didn't work it is a normal glue

PLAでも大型モデルを印刷すると、どうしても端が反ってしまい困っていましたが、この製品を使い始めてから全く反らなくなりました。ホットベッドに薄く塗るだけで、印刷の最後までガッチリと定着してくれます。もっと早く出会いたかった製品です。

3Dプリンターで使用していました とても頑丈に引っ付きます ただ、あまりにも頑丈に引っ付くので あまり最近は使用していません 最近はマスキングテープを張ればたいてい90％台座に引っ付くようになったのでPLA時はマスキングテープのみを使用しています、ABSは台座にとにかく引っ付かないのでマスキングテープとノリを合わせて、ABSのみこの品を使用しています。