Sink Clips Undermount Kitchen Sink Clips, Epoxy Undermount Sink Brackets Supports for Bathroom Kitchen 10 Pack Kit

First of all, they came fast, next day to save us, our own box store didn’t carry. We tried to install a large, granite, sink with what was sent with the sink and they sucked! These were ordered an hour into install and showed up the next afternoon. Installed right after and I finally feel confident having an under mount sink installed, easy and secure. I am confident with these brackets and way easier to do. Had I known, I would’ve bought these first and thrown the provided ones in the trash. Thank you! Things aren’t hard, don’t overthink it, these make sense.

I used these clips to mount my slop sink to the underside of a butcher block countertop. The mounting plates have six (6) mounting holes to hold to the countertop substructure. I used four #8 X 3/4" stainless steel pan head screws in the outermost mounting holes. The included wing nuts are just okay. I would want a pair of pliers to tighten them well. Instead, I went to the hardware store to purchase 1/4"-28 nuts (NOT 1/4"-20) with star lock washers to replace the wing nuts. You could probably stand inside of your sink after using these mounts. Well designed, made of good thick steel metal, but the wing nuts should be replaced for nuts you can tighten with a socket or nut driver.

The only thing I didn't like but it wasn't a problem was there was nothing to stop the screw from spinnig when you went to tighten up the wing nut. I used liquid nails and also 2 small screws to fasten it under the counter top. Worked great for our camper which had no clamps at all which caused the sink to come loose and fall down into the cabinet.

Worked perfectly, using the recommended PC double syringe epoxy. My sink dropped about an inch on one side due to too heavy an item stowed in the sink. I was concerned about the epoxy holding since I couldn't disassemble the sink in my RV, I had to apply from the bottom. All went well with a nice snug fit. What could have been a complicated project turned into a simple fix. I recommend this product.

These will likely work with a new installation only. They won't work for repairing an existing sink that's broken loose.

these clips were not in stock at my hardware store, The big A had them and got them fast, worked perfect

What did you expect for $12? The photo tells the story, these clips are cheap. The bolt is not attached to the epoxy clip which as another reviewer points out causes the bolt to spin. The clips are thin and not as thick as shown in the photo. And they are smaller than as shown, see the razor blade for scale.. There is no way these clips are going to hold up a dual kitchen sink full of water. What a waste, straight into the trash they go.

Product did what it was supposed to do. There is a small design flaw. A bolts that the wing nuts screw onto are not attached to the mounting plates. The manufacturer needs to thread them out in plates so the wing nuts will not just spin on the bolts when you attempt to tighten them. Problem became obvious very quickly. Use a little epoxy to glue bolts to the plates. It made for a very easy install.

This product works as expected and did the job well. Solid product that will last.