PC Products PC-Pool Moldable Epoxy Putty

Had a leak around one of our pool return jets. this epoxy stick was easy to use. Just cut off a section from the tube and kneed the two together until a consistent color. Placed the product around the underwater leak area and carefully molded into the area of the leak. It hardened underwater in about 10 minute and completely solved the problem. Did not have to drain pool down below leak. Excellent repair and solved the problem. Yes I recommend and very satisfied

This product was an excellent choice to quickly resolve a leak in my in-ground swimming pool. My leak was on the exterior of one of the 1½" Schedule 40 PVC pipes penetrating the side wall for the pump return jet. In my case the fitting for the jet nozzle was a friction fit to the pipe interior, so I slid out the jet nozzle so the junction between the 1½" PVC pipe and the cement / Diamond Bright wall was exposed. A utility knife was used to dig out any loose cement / Diamond Bright around the pipe prior to starting, increasing the leak slightly at this point. A suitable length of the epoxy rod was cut off, then mixed by hand until a uniform color was attained. That mixed epoxy was forced into the gap between the 1½" PVC and the cement / Diamond Bright, until I was unable to push any more into the gap. The leak was identified prior to the repair using liquid food coloring and a children's oral liquid medicine syringe. This permitted placing very controlled small drops of coloring in the water near the suspected leak, then watching the water flow forcing it through the wall gap. Once the epoxy repaired the leak, the food coloring demonstrated the leak was fixed.

had a crack in above ground skimmer neck. did not want to drain water to replace. used the putty as directed and it stopped the leak and last the season. Good product.

It worked and it sealed the leak but it didn't last. Maybe I didn't get the surface clean enough for something but it didn't hold for more than a few weeks.

Work well for spot treatments. Dries quickly and can be applied underwater.

Didn’t stick under water.

This epoxy is the best ever! No more mixing liquid 2-part epoxies and wondering if you squirted out an equal amount of each, then having it drip all over. This epoxy is clay-like in consistency, so you just cut off whatever size you deem necessary, and knead it. It even can be applied under water.

Product works like other stick epoxies I've used before however it turned out to be useless to patch my pool. It doesn't have enough "stickiness" to adhere to the concrete. If you're filling a deep small hole this should work, but if you're patching a thin shallow hole then look elsewhere