ABS Electrical Junction Box, Ventilated Design, Cable Grommets, IP65 Waterproof Enclosure, Indoor/Outdoor Use with Mounting Panel (Clear Cover, 11.8"x7.9"x5.1")

Light show box and in the open. Great look and perfect application with plenty of space. Two 12v power supplies, controller board, and 16 output cables, plenty of space.

Used this in an off grid gate opener. Has kept the solar charge controller dry for over a year. Several options for size so make sure you measure what you need to install. Grid in the back makes it nice to mount things(solar charge controller in my case). Vents on the side were the reason I bought this one. Zero issues with heat or bugs in 100 degree NC summer

Good secure weatherproof box. Easy to mount and easy to mount keypads inside.

Bought this to put in our pool house to hold a starlink mesh node to extend our coverage further in our backyard for cameras, speakers, lights and such. Pool house is enclosed, but no heat or insulation, so I was worried about the moisture. This seems to be protecting it, with no overheating. Box is heavy duty and well made. Will update if we have issues through the winter.

Very nice design, but the box has rather thin plastic. Good value otherwise.

Used this for a Starlink install on an apartment building roof. Client was convinced he needed Starlink (despite having TWO cable providers in the building), and so I needed a box to house the power supply and ethernet terminations. Chose this partly based on price and partly due to it meeting sizing, transparency, and cable routing needs. It's a well built enclosure, with a decent selection of gromets for passing cables in, however I don't think the ventilation is going to do anything as the vents are passive and there isn't going to be any chimney effect to draw air through as they're located on the sides of the enclosure instead of the bottom. I can understand that due to not wanting standing water on top of the enclosure to come inside, but they could have staggered them horizontally to give it some vague change of drawing colder air in through the lower one and letting hot air out through the top. Saying that, the shrouds point downward, so it's like having a pea trap in your sink waste pipe, so I doubt even that would do anything. If this is an issue, I will have to mount some case fans on the inside of the top two vents and push air out, however that's going to be a pain, and I doubt the starlinke power supply is going to get that hot, so I'm probably overthinking it. I would have liked to see some better options for mounting. This was bolted to a rail by drilling a couple of holes in the back and using metal zip ties around the rail it was mounted to, which should do fine, but it wouldn't be difficult to set some nuts into the plastic to allow mounting hardware options on the outside without compromising the water-tightness of the enclosure.

Box does outdoor box things to protect my house's outdoor lighting power supply and controller boards. Things are a bit tight in my configuration, but it's not let me down yet. Held off many central florida thunderstorms and hurricanes as well as daily sun/heat. I will definitely come back and buy more of these as I expand my outdoor lighting.

Perfect for what I needed it for. I attached this to the backside of my house so that I had a place for my Govee house lights cables to be tucked away safely. This was the absolute perfect size for the power brick and the power button. With a plug in the soffit all that was missing was cable management. This was extremely easy to install. I went with this option because it has the little rubber plugs for different cable sizes and you didn't have to cut any cables or open any holes up bigger to put a plug through unlike a standard junction box. The latch works really well and closes the box up tightly. The seal is good as everything inside has always been dry! I would highly recommend and I would purchase this product again if necessary.