Geekworm Case for Raspberry Pi 4, Universal HAT Size Pi Case DIY Kit, Protective Acrylic Case for Pi 5/4B/3B+/3B/2B/B+ and Pi Hat Expansion Board

This is just the protection I needed for a Pi3B+ running a squeezelite player on Raspbian. I tried the bare squeezelite player first, but had problems getting it started. Tried again with synaptic and it worked perfectly. The cutout for the next layer of GPIO pins is place correctly for the pins that can be added to a HiFiBerry DAC+ which as I type is playing beautiful music wirelessly. It replaces an OLD wired squeezebox. The best instruction for putting the pieces together is the picture on the Amazon page.

Simple, basic, and cheap. Open air design is great for a set up with no fan.

It gets the job done - secure the RPi 4 and its hat in place nice and tight. I wish they make a matt version of it though - the high shine surface of the two plates are two huge scratch and fingerprint magnets. It only looks nice the first minute after you take off the protect sheets, then it is impossible to keep it clean and shine.

If you have another to board with the exact same mounting holes, this also works perfectly. I bought this for use with a Libre Computing AMLogic Le Potato board. Works very well and snug throughout. The group hole is slightly off, but it doesn't really matter for my builds.

I only wanted this for the bottom layer of acrylic, so for the longest time the top just sat in my drawer. Yesterday I decided to put the top on, and to my surprise the hole in the top for the GPIO passthrough does not align with the pins at all. I can't figure out why the cutout is even there.

This was a great solution for my PI and a RF base station hat that has a wire antenna. The metal spacers are far sturdier than the usual plastic ones I have seen. When you don’t need walls, this is a great enclosure. I added my own feet to the bottom. My only nit was that it should have come with feet.

I bought this for the OrangePi 3B v2.1, the only items I was able to use from the kit were the screws and standoffs. I needed this for the usb expansion hat I added to my pi.

I used this case for a Raspberry PI 2B with a Digi HAT. The case was easy to assemble and I had no problems fitting the Raspberry PI 2B. The case was exactly what I expected for the money. Good low cost case.

Pour remplacer un boitier qui fait court circuit. Dommage qu'il n'y ait pas de pied caoutchouc, et pas assez de vis pour le dessus, les deux récupérés de l'autre kit

Utilização com DAC com Raspeberry Pi 4 só foi possível com troca de espaçadores e adição de anilhas (não incluídas) . Diferença, para menos (3 mm), na montagem tal como apresentada.

Funzionale ed elegante. La soluzione ideale. Io l'ho usato con un Raspberry Pi 3b e il Raspberry DAC Pro. Perfetto. Suggerimento: 4 piedini in silicone sotto. Altrimenti poggia sulle viti e potrebbe graffiare la superficie

Nacht macht es soll.

I like these cases for experience.entation with RPI hats.