GRAUGEAR 3.5 Inch Front Panel Hub, 4 Ports Internal Metal USB Hub, 2X USB-C 10Gbps and 2X USB 3.2 Gen 2 Ports, USB3.2 Type-E Key-A 20-Pin Header & 15-Pin SATA Power Connector Required [G-MP02]

Easy installation, sturdy product, and transfer rate of USB Type-C is perfect.

Just what I needed. Building a new computer for wife to hopefully be good for years. The MB had a new type USB C port The case had no usb C port but does have 3" front panel knockout. This gives me two more type A usb3 and added two USB C 3 ports on front. As bonus, system will boot from these extra ports, unlike PCI added ports on my computer. It was a pain getting the unit physically attached but that had more to do with the case not having easy access to retaining screws. Still not as bad as the finger cutting setups of the early 2000's.

It is working well.

I was upgrading my motherboard but re-using the old case. This was an easy way to add USB 3/2 ports to the front panel. The data cable plugged right into my motherboard. Installation was super easy--just placed it in an unused 3.5" bay, plugged in power and data cable, and good to go! No setup required.

Mine came defective on arrival. I could change devices from 3/4 of the ports, but not transfer any data. When plugging in a eHDD the activity light would turn on for half a sec then turn off. I assume the usb hub chip was fried or something. I'll try ordering a second time and update my review if all goes well.

Good when it's 'on'. Easy install. drilled holes in the plastic for the mounting screws require a bit of caution but were lined up with my case well enough. Otherwise easy install, no drivers, comes right up. Good 3.0 speeds. only complaint, is it occasionally falls off the bus (pun intended) which is a little weird since it's actually POWERED. I have two different powered external usb hubs and neither one ever just drops like this. As simple restart gets it back. AND this happens rarely enough I can still give it 3 stars/

The case is metal, not cheap plastic, and the circuit board appears to be a high-quality product. This is my first Graugear purchase. I have other front panel hubs in other computers but this one seems to be much more high-end in comparison.

I needed extra USB ports on my new build. THis was easy to install and plugs into mother board and a SATA power plug. Fast USB with this. Fit in my old DVD drive slot. Very happy with this.

Fiyatını fazlasıyla hakkediyor. Hızı muhteşem. Tavsiye ederim

Zeer snelle gegevensoverdracht. Het moederbord moet wel over de juiste aansluiting beschikken en de USB stick moet natuurlijk ook 3.2 gen 2x2 zijn.

PCケースのフロントパネルから伸びているケーブルの問題か、はたまたマザボ側の問題か分からないがフロントパネルのUSB Type-Bの3.0が壊れているので、ついでにType-Cも増設できてKEY AのみでOKな本品を即決。 ３.5インチなのでstartechの5インチベイと組み合わせて設置。 後はストレージ3つにCD DVDスーパーマルチと本品とでSATA電源足りないのでこれの分岐も追加購入。 フロントパネルにつけてSATA電源つけるまでは順調でしたが、どうもKEY Aがうまくいかない。なんかグラグラするし、すぐ抜けるしWindowsからは認識と切断音が繰り返し鳴って詰まるところ認識しない。しかもKEY Aって調べても全くと言って良いほど情報がない！というわけでまとめます。 《KEY Aのここが困る！》 ・マザーボードによって名前がKEY Aでない事があります。私のマザーボードはMSIのMAG B550Mですが、「JUSB1」という名前です。あとこのマザボだと10Gb/sでないです。 ・他の方のレビューであったので気をつけましたが、向きがあります。写真を見ていただくと分かりやすいですが、上下のフチ？の広さと、長さが揃っていない点で判断してください。最も、私のマザボでは向きを間違えると刺さらないようになっていました。 ・軽く刺してすんなり入ったら、その後しっかり押し込んでください。カチッというわけではありませんが、USBの差し込みくらいの硬さでしっかり奥まで刺さります。 というわけで、私はしっかり刺さっていないことに気付かず、1時間以上あーでもない、こーでもないと格闘してました。まあ自作あるあるですが。参考になれば幸いです。というかKEY-Aの存在感が薄すぎるのがいけないんや…。

Funciona muy bien. El móvil lo carga con rapidez, y los datos también van muy fluidos. Estoy contento con la compra. Ahora tengo cuatro puerto rápidos en el frontal del PC. Hay que mencionar que, si la caja no tiene la bahía de dimensiones adecuadas, hay que montarlo en un adaptador, que hay que comprar por separado. Por lo demás, perfecto.

Costruzione praticamente perfetta, frontale ben rifinito e logo che non è un pugno negli occhi (bravi!). Funziona anche nella mia scheda madre che non ha l'ultimissima versione USB. Il principale vantaggio di questo dispositivo è che richiede solo un singolo cavo interno Type-C in cambio di due porte A e due porte C, quindi se siete in penuria di connettori interni ad alta velocità lo consiglio. Ottima anche la scelta usare il SATA come fonte di alimentazione, così non vi risucchia troppa corrente dalla scheda madre e non deve fare razionamento sovietico se riempite tutte e quattro le porte, le Type-C caricano sui 10W che non è male. Piccola nota per chi ha esigenze tecniche molto particolari: le quattro porte sembrano smistate con uno hub USB (piuttosto che essere instradate direttamente). Se la cosa vi importa però probabilmente lo sapete già