Plasterboard Cavity Wall Fixings Hollow Wall Anchors Heavy Duty (Pack of 4 Fixings)

Purchased these ones on multiple occasions, Very strong and sturdy if you need to mount something heavy and you can't drill into studs I would highly recommend these fixings. (Advice on installation) I used these a while back without any problems until recently I forgot that you have to thread the red plastic wire in the middle and one of the the side holes doesn't matter left or right hole and not the two side holes excluding the middle hole. It's very important otherwise if you thread through the two side holes and try to screw in you main large screw in the middle first you will have trouble, one - screwing it in but if you manage that, two - the red plastic wire could snap if you pull to hard you don't want that you will lose the large plastic piece down the back of the wall which is what happened this time wasting a fixing, three - the small screws for the two side holes won't line up and you will be screwing for eternity and nothing happens. (Steps) 1, Drill your hole 2, Cut the red plastic thread to size be generous (20cm to 25cm) more length more grip you can reuse it for multiple fixings as long as you don't snag it or damage it check after use for damage before using on second fixing and don't pull to hard it will snap. 3, Thread the plastic wire through the centre hole and one of the side holes on the big plastic piece making sure the flatter side is facing you. 4, Push the large plastic through the hole in the wall holding the plastic wire make sure the flatter side will be against the back of the wall or facing towards you. 5, While holding both strands of the plastic wire with one hand firmly, start threading the plastic wire through the other plastic round cap remember through the same holes. 6, Holding the plastic wire push the cap into the wall. 7, Screw in the small screw in the vacant hole until firm not to much but not to slack. 8, Now pull the plastic wire out you don't need it at this point anymore, screw in the other small screw in the other side, (tightened both sides fully) 9, Now finally you can screw in your large main screw. Hope this information is useful and saves some of you some time, your welcome! 😅

Have used these kits to fit 2 32-inch TVs in a new-build property with ‘dot n dab’ plasterboard/block walls. Such a simple, but highly effective and incredibly strong solution. Would definitely recommend.

Very good, did the job

Best things ever created, some of our walls are flimsy plasterboard and hanging heavy items seemed impossible until we discovered these. Perfect for hanging our tv’s and a 20Kg bathroom cabinet.

So i took up the task of putting a tv bracket on my bedroom wall then realised its plasterboard !! I am no powertool girl i usually just have the ideas but with no help and zero patience i decided i was doing this on the 29th dec i found reviews on this item to suit my needs the best and once they arrived i started. The instructions were very clear and easy to follow. The fixings were so easy to fit behind my plasterboard i literally had them done in no time ( with spare holes drilled ... my fault not the instructions.. i repeat im no powertool girl ) But these fixings made hanging my bracket so simple and quick to do. Once on the wall i tested the bracket by hanging from it myself to test my handywork ( im no feather ) and it stayed put so next on went the tv..... Long story short a month later the tv is still on the wall and i have Netflix in bed 😊 I highly recommend these fixings when fixing to plasterboard walls they are simple to use very quick to install and strong

Superb for those really heavy jobs in plasterboard. Having use a variety of so called infallible plugs before I was sceptical at first but these are really strong. Absolutely right rock tight fixing. Easy to fit, although drilling a 2.5 cm hole in your wall might worry you initially, once all the pieces are in place you will be pleased you did. I wish I had found these years ago.

I’ve used a variety of anchors through the years, my favourite being the Fischer duopower, which are my go to for masonry and even plasterboard for some jobs. However, this time I was looking to mount a 30kg mirror on a stud wall and I needed to be more confident it was going to be secure, while duopower ‘could’ manage it, I wanted something definitive. I’d seen the geefix recommended on YouTube a while back, and had previously heard of gripit but the results across the web for the latter were disappointing, I’d have more confidence in the Fischer if there was nothing else. The geefix however are fantastic. Just be sure to read the instructions. Many of the errors in the lower star reviews (from my experience) look to be user error. Drill the 25mm hole with a hole cutter, feed the wire through the geefix, pull tight and slowly screw using the central screw. If it spins, it’s not being held tight enough. Once the screw has bitten, remove the wire and use the two smaller screws to bring together tightly. You can then use either the supplied screw again to mount or my preference was to use a slightly bigger reisser screw. The mirror is now nice and secure so the next pack I purchased are to mount a TV in the spare room. I would throughly recommend these, take your time, follow the instructions and you’ll have a very very solid fixing.

Great product works as described recommend.

Se avete bisogno di stare tranquilli e caricare abbastanza peso questo è sicuramente uno dei migliori tasselli per lastre di cartongesso. Ho fissato un supporto TV ad una parete con doppia lastra di cartongesso commerciale e sembra molto solido. Certamente non farò la prova di sollevarmi al supporto di peso come mostrano le istruzioni. :-)

Fäste ett beslag för en ledstång i en gipsskiva som tidigare lossnat pga för enkel plugg. Geefix fungerade bra men behöver ett 25 mm hål så det gäller till att det som fästs kan täcka över det.

aber ihr musst auch sicher sein, dass sich hinter der Wand ein Hohlraum befindet! (Bei mir war das nicht der Fall, zumindest nicht dort, wo der Fernseher angebracht werden sollte. Dort befand sich eine Sandwichkonstruktion aus doppelt beplanktem Gipskarton, eine feste Isolierschaum und dann der anderen Wand. Glücklicherweise bin ich zuerst auf einen Holzbalken und dann auf Metallbalken gestoßen, sodass der Fernseher dennoch sicher hängt.) . Das Produkt entspricht ansonsten der Beschreibung, wurde schnell geliefert und macht einen sehr guten Eindruck.

55' in gyps board. No problems