Network Cable Untwist Tool, Engineer Wire Straightener and Wire Stripper Set, Dual Headed Network Cable Looser, Cable Stripper Twisted Wire Separator for CAT5 CAT5e CAT6 CAT7

I was skeptical that this would work but it saves time/fingers. For the price, it's worth it if you're doing more than a few ethernet cabels.

crazy simple to use and SO nice for untwisting and straightening in one motion!! these things should just be part of the connector clip kits!!

I put on about 50 RJ45 connectors this weekend, and these two tools ended up being the mainstay of the job. The cable stripper we are all familiar with, and it worked fine. The brass "untwister tool" I had to fool around with a bit, but ended up using it as follows: (a) in each twisted pair, put the tube over one of the wires and push it towards the base of the strip, twirling it as you do it so that the two wires end up separating. (b) slip the tube down over each separated wire, bend it 90°, put your thumb over the opening to trap the wire and pull outwards, straightening the wire using the rounded edge of the tube as an anvil. This sequence allows you to have eight straight wires at the end of your cat cable in a pretty short time, without damaging the wires or killing the skin on the end of your fingers. Really nice.

This has absolutely changed the game for prepping twisted pairs for termination. Sore fingers, say goodbye! This has earned a permanent place on my tool belt and has cut my termination time down by about half.

This little tool works great for untwisting the the CAT 6 twisted pairs and straightening them. It makes working with pass through RJ-45 connectors so much easier.

Good value for usage

Excelente

It works it’s just nothing special. Cheap and effective most of the time lol

what a piece of junk.