Enttec Open DMX USB 70303 Lighting Interface - Open Source/Hardware Only - Entry Level Model

I outfitted several venues with this unit. Provides reliability and connects easily. Send signal well, we use Lightkey. Never have issues with it. Small and easy to hide in setups.

Used this for an eight-light DMX setup in my small dueling piano club. After some research into the right DMX software, setup was a breeze. No problems after a solid month of use. Very pleased with the value.

Soy Dj ,y este producto está 10/10 ,se los recomiendo ,ya lo he utilizado muchas veces ,me encanta la calidad

I bought this to work with QLC+ (V4 AND V5). It worked no problem right out of the box. I am doing lots of complex efx and RGB Matrix functions with my lights so there are a ton of DMX commands going out. I know this because I tried to use wireless DMX and the wireless got overwhelmed and couldn't keep up. This little box wired to my lights works fantastic. I took off 1 star because I really think they should have put a 3 pin DMX/XLR socket on it vs the 5 pin. The 5 pin required me to go get a 5 pin to 3 pin adapter. My guess is that anyone going cheap like this on this device ISN'T going to have a bunch of 5 pin DMX cables. They will likely be using standard XLR's (like me). Anyway, this device works great even under a serious DMX load. Also, lots and lots of people using it for a ton of different programs (not just QLC+). If you are looking to get into some more complex lighting using a software like QLC+ to build your lighting solution with, this is a great little device.

This little converter saved my life. I thought I would need the pro version, but this was fine. I’m using it to communicate with a DMX splitter to access a DMX controller that already has a DMX console hooked up to it.

I bought this to use with QLC, and it worked just as intended. However, after one month of very light use, it suddenly started randomly disconnecting from the computer, leading to a lengthy reset process, and a part we cannot trust to use during shows.

I got this to replace a small lighting board (wanted to try it with Lightkey software for Mac ) im using this with a 6 moving heads, 6 bars, 2 dimmer packs with 6 source four lekos and a few washes so far so good is pretty much a plug and play device light software detect it right away and no issues . Will update after a few uses .

I've been troubleshooting issues with the Open DMX USB for about a month now, and I've come to the conclusion it just doesn't have the driver support needed for a device like this. I tried a few different lighting softwares, and this unit had issues with all of them. Since it's open-source, Enttec seems to have washed their hands of any notion of proper driver/firmware support, so you end up being basically on your own. Buy the DMX USB Pro instead, I promise you'll be saving yourself a lot of headache down the road. It's worth the extra cost.