RG8x UHF Male Crimp Connector

I was very pleased with the quality and cost of these connectors. The fit RG8X coax perfectly. I found them very easy to install, but you do need to have the proper crimping tool to install them. I like to have all of my jumpers and coax runs at the perfect length. With these connectors, I can have professional looking perfect sized jumpers to clean up the wire mess behind my equipment. The durability is good, but for extended outdoor use, I recommend wrapping the connector with a coax sealing tape since they are water resistant, but not waterproof.

Received in brand new perfect condition. Great coax connectors. They work great. Will buy again in future when needed.

Some have said that these do not fit on RJ8X coax, but actually it fits perfectly. The tolerances on these are very tight and if you don't pay attention when putting them on, it will seem like they don't fit. They are tight when they go together, they crimp down perfectly, they come with quality shrink tubing to keep everything looking clean. I think the price is reasonable for the quality of the product. I have decided that these are the connectors I'll use for my shack and I will be putting them on DX Engineering DXE-8X coax. I have made several cables and they are all working very well.

Good enough for hamateurs like myself!

Buen producto, bien fabricado

Not much I can really say about these crimp connectors. They aren't the super high end model, but when DYI comes into play, especially for the first time, they did just fine! For the money, great value. For the ease of use, well that's an experience thing. I was able to successfully put an end on a damaged feedline of mine, and the connection is working. I don't have super high end equipment to test and vet the feedline, but it works! To me, that is all that matters. No major loss and/or audible interference. I went 5/5 on the rating, but there are some drawbacks. First, the heat shrink sleave could be longer. Second, it does take some getting used to performing this task. But again, that is more on the operator than the product. All in all, I would buy them again. I just hope I don't have a need for ten (10) ends, except for perhaps making niche cables for the shack and portable station!

There exactly is described and I receives them in a timely manner. They will work just fine with what I'm going to use them for. Although I prefer a style of connector does the sleeve is longer for a better crimp on the shield and some strain relief.

These connectors were supposed to be good for RG-8X. I noticed the crimp ferrule was very tight when slipping it on the coax before stripping the RG-8X coax. The coax measured 0.26 inches diameter. I about an inch and half of the outer insulation and shield braid and foil. Then I stripped an inch and quarter the inter insulation to expose the center conductor. When I used this type connector many years ago, the tube extending from the connector to the entering coax would slip between the inner dielectric insulation and the shield braid with the outer insulation unstriped. Then you would slide the crimp ferrule over the whole tube, shield and outer insulation to Crimp the shield to the PL295. BUT the ferrule would not fit. I had to cut back the outer insulation so the ferrule would fit to crimp. And so far the cable will not pass an RF test at low frequency (3.5 Mhz). I like the pre cut heat shrink with heat activated glue. nice touch. Hope this makes sense. Not pleased at this point. But still willing to find out how I might have gone wrong.