LeMotech ABS Plastic Dustproof Waterproof IP65 Junction Box Universal Electrical Project Enclosure White 5.9 x 4.3 x 2.8 inch (150 x 110 x 70 mm)

What would you use this box for? As an amateur radio operator I would use it for a coaxial cable entry point for my shack. Where the box is usually mounted low to give better access to earth stakes and where the cables come in beneath the radio. And for this it is perfect……until you go and try and reattach the lid. The holes for the lid screws are large but the screws are tiny. Not even my magnetic screwdriver could hold the screws horizontal enough to get these tiny screws centred in the large hole. Much swearing, much dropping tiny screws in the dirt, a sore back from stooping so low for so long and I was ready to kick this box to kingdom come. In the end the only way I could do it was to dip my screwdriver in silastic and shine a very bright light down the hole. Success at last but my plan to cut back drinking has failed tonight.

Se recomienda amplia mente muy buena calidad

I bought this to house a circuit board that contains a wifi antenna for remote control of my pool pump. The requirements were that it be weatherproof, bug proof, and looks fairly good. First off I had to drill through the back to create mounting screw holes. Not a big deal. Second, the rubber grommets were high quality and you can cut through them to insert wiring while maintaining a fairly tight seal. No creepy crawlies going in so far, but as for weather I'll have to wait a year and update you. We get extremes in weather, 30 degrees Celius in summer, -30 degrees in winter. Hard on electronics to be sure. If you are using it as a true junction box you won't be disappointed. Ok one year update. The plastic corners are cracking, likely due to weather. Where I inserted the wires spiders are getting into the smallest holes. The gasket between the box and lid falls out, but I guess that's minor. I've learned that I need to seal the gaps in the grommets with silicone. I wanted to paint the whole thing black and whilst the plastic is easy, the soft rubber grommets did not take the spray paint well, leaving them sticky. Any suggestions? The electronics held up.

I have ham radio antenna coxial running into the box, lightning arrestors, grounds and coax out of the box and into my "ham shack". This box is well made, well designed and easy to use.

防犯カメラ屋外用、センサーライト電源中継ボックス用に購入しましたが軽量ですがパッキン付きで安心です。