Libre 2 Sensor Covers 25Pack (tan)

Works great for the Libre 3 Plus that I use and the Libre 3 before that. Make sure area is clean. Adhesion may be a little weak but for me it is fine. I normally put one on at time of sensor install and then after about a week it might start to peel away so about half way through the sensor life, I will remove and put a new one on. Essentially using two sensor covers per sensor. I did have one that required 3 but it was in summer and hot so probably sweat caused it to come off sooner than others.

I have been frustrated with the Lebre 3 sensors falling off or stop working after a shower so I thought I would try these patches and see how they work and was happy with the results. pros: 1 they offer great protection against premature falling off of the sensors. Mine actually stayed on the full 14 days with the use of these patches 2. while not 100% water proof they do go a long way in resisting water while showering 3. the center section does not have adhesive which allows it to be applied with out actually sticking to the sensor cons: 1. the film that has to be removed from the adhesive is difficult to remove and the instructions for use really doesn't work well it is far better to remove all the film before applying than just the center section and then trying to remove the outer section once applied 2. the down side of having such good adhesive on the patches is that they are a little difficult to remove when needed and if you don't hold pressure on the center of the patch to hold the sensor in place while removing the patch you can easily pull off the sensor conclusion: if you have trouble with your sensor falling off prematurely then this patch will be well worth the price

Maybe I got a bad batch as I rarely got 14 days out of the covers. Some lasted about 10 days, but a majority of them lasted a week max. I did proper preparations to provide optimal adhesion but never got these to stick properly. The edges peel easily and lost a bunch when removing my shirt.

I’ve purchased these honyou adhesive patches twice. The first purchase the adhesion was very good with the latch staying in place for the full 2 weeks before showing any signs of peeling of falling off. The second package, which I’m currently using, the patches tend to curl up, lose adhesion and fall off within hours after applying. I use alcohol pads vigorously in the area prior to applying the sensor and the patch. The price is great, the fabric is comfortable, it’s fairly easy to apply considering my arthritic hands. My only complaint is the adhesion, or lack of.

This has been great since I started using it. In the past, when I bump a door jam or something I have had the CGM come loose. To avoid that I’ve used sports tape. That has helped, but it has also been problematic. It gets frayed and has to be trimmed. And if you need to remove it and replace it with fresh tape, it sticks to the CGM and you risk pulling it out. With this product, this is never been a problem. There’s no glue that covers the CGM part. So needing to remove it the CGM is going to be fine. Having said that, I have only once had one of these patches needing to be replaced. I have even put one on at night after a shower with my skin, a little moist still, and then sleep on my arm. Now the patch did get wrinkled, and I was afraid I would have to replace it, but I didn’t. It stayed wrinkled for the full two weeks. The only problem is when you put it on the paper backing sometimes doesn’t pull off the way it should and it takes a bit of extra effort to get all of the paper off. I only had to replace one patch. It was because not all of the paper came off and so it didn’t stick right and pulled up and didn’t cover the CGM

Just got around to using, the patch for sensor apparently doesn’t have enough adhesive on it as it falls off in less than 12 hr! Never got wet!!😠

The diabetic in my family has enjoyed using this type of sensor cover, and not just because of the fun colors. They are fairly water resistant IF you put them on correctly: smooth with no wrinkles. If applied unevenly (wrinkly) water of course gets up underneath and weakens the adhesive. We have found that if improperly applied one cover lasts about three days, but if applied well without wrinkles it lasts at least a week. We will continue to stick with this brand.

I gave my third cover a try, this time holding the center and peeling the backing off. It adhered much better but I wish the manufacturer would only put 2 peel off backing pieces instead of all the smaller ones. Some pieces were hard to peel off thus causing folds that were hard to smooth out. Please note the picture shown is the original pic I posted. Old review: Within the same day, the edges started peeling. No matter how clean your hands and skin are, the edges started peeling to unstick and roll, especially if you are active. This is my second one in 3 days. I don’t see how they could last any longer than what is claimed.