010480 Cell Saver Battery Insulation Kit

Having had a misfortune of a fairly new battery becoming defective due to discharging due to either alternator not charging / or battery leak. Decided on extra protection for the battery found this item came from America. so far so go. i would recommend this for your battery protection.

This product worked great for my Nissan Murano Group 24F battery. My old battery had an OEM insulator, but the new battery is bigger. The old insulator does not fit, and there is no OEM replacement, so I bought this kit. The kit includes 40" x 7" insulation, and a 12" x 7" base mat which is a nice addition. I have included pics of both sides of the material. The base mat does not have a reflective side. I did cut the insulation to accommodate for the ears on my battery. For this particular battery which measures approximately 10.5" x 7.0" x 7.4" I cut off about 6" from the length of the insulation, and also cut two indentations for the ears on each side of the battery. This was so the insulation would be completely flush against the battery. I also cut the base mat to form, so it would fit into the battery tray. I would not have to had cut anything to use this product. (Not even for the battery tray.) I only cut to have a more professional look. However make sure the insulation is below the terminals and connectors to avoid any contact so it does not arc. I did test the foil side with a multimeter for continuity, and this will conduct electricity! So make sure not to get this close to the battery contacts. Also, it is dangerous to try and cover the top of the battery with this. So this will need to get cut if the battery is less than 7.0" tall. This is not intended to cover the top. I am very satisfied with how this turned out. The quality seems good. It took a little effort to cut with a box cutter, so it won't wear or tear very easily. I would purchase this product again for my next battery.

Although they stated on here it would not fit my battery. This product has no measurements here to see. I know it will fit most batteries and can be cut down to size, if smaller. Worked for me and easy to use.

To small for my battery , there was no clarification on what battery sizes that fits, no refund, total waste of money.

After doing my Turbo setup in my Honda S2000, my battery started to melt on the top (see the second photo). After every drive, I was able to deform the "cap" part of the battery because of the radiant heat under the hood. I just installed this Batteryr isolator kit, and since I got a small battery, I was able to wrap it around and on top of the battery. I tested after few drives, and now the "cap" of the battery is no longer melting after a drive, it is hard as it should be, this kit really block radiant heat. I recommend this product