YUNGUI 10 Pieces 73mm x 100mm Circuit Board Copper Strip Board,957 Holes PCB Board Prototype perfboard Kits for Soldering and DIY Electronic Project with Arduino Kits

Was very impressed. Excellent copper traces, solid. I use a dremel to cut to sizes I need, works well and the traces stay solid even where the blade cut in half, they don’t fold up or get messy. Just what I’d hoped.

Cheap enough to make mistakes and to use a whole sheet. I was taping pieces of Press and Peel to the printed artwork and then reprinting,making sure to send through the printer in an identical manner. Now dont have to . Better adhesion to the copper. washes off easyer.

Beginners are going to have a pretty hard time with this one if they make a mistake. Applying excess heat to the pads will lift the traces. Make sure you have flux on hand because for me, the solder just didn't seem to hold well

These boards are a very good value. That said, there are trade-offs for the low price. At least one of the boards didn't have the holes in a straight line, but they weren't so far off that it affected usability. Most of what I received don't have the holes centered very well on the copper strips. Again, they've been usable. They don't tolerate rework very well. If you need to desolder something, even with care and attention you're likely to damage the tracks. All that aside, it's ten big boards at a great price, and I plan to order more.

These boards get mixed reviews, but I like them. They serve my purpose. I like that they are easy to cut down to smaller sizes when needed on my band saw. I have no issues with them. They are a great low cost board for my projects.

Never had any issues with delamination, pretty easy to cut with several passes of a razor knife on either side. I use a handheld 1/8" drill bit to make cuts in the traces, and to slightly chamfer holes on the plain side to help insert stranded 22 awg wire a little easier. Would buy again.

It works fine, but the backing is very brittle compared to the more costly vero board, so you need to be very careful when cutting or snapping it.

Good for making prototypes when you need something more permanent than a breadboard, but are not ready to have custom PCBs made yet.

good

Muy bien producto para proyectos electrónicos, muchas gracias.

Works like it should

Stick wears out after a year.

Not Gold Plating and not plated holes. Just plain old veroboard.