Wirefy Male Spade Connectors - Heat Shrink Spade Connector Kit - Quick Disconnect Wire Connectors - Electrical Spade Terminals - Red 22-16 Gauge 150 PCS

They work fine but one of the connectors is not covered and can cause a problem if not wrapped

Like being able to stock up on connectors for a very reasonable price. The connectors work as they should. To create good connections with heat shrink connectors, you must use a crimping tool designed for that type of connector. Otherwise, the crimp will fail to hold and/or you will cut the tubing, destroying its integrity. Also, recommend an electric heat gun for best heat control. Ask me how I know all this first hand! Really like the hot glue adhesive inside the heat shrink tubing, helps seal the connection and hold the wire in the terminal.

These and the mating connectors work extremely well for portable amateur radio connections such as for a linked dipole. The heat shrink tubing with adhesive forms a very good strain relief for 18 - 22 gauge wires such as silver Teflon wire used in these antennas.

I use these connectors in a 12 volt system and they work great. Seals tight and easy to crimp.

The connectors are really thin and would barely hold a 10 ga wire. They did not look like a tinned copper to me and so I put them through my trusted Extech Milliohm Meter. As a reference, I used a comparably sized Gardner Bender spade connector, which is also rated for 10-12 ga wire, and is verified to be tinned copper. As you can see in the photos, this Wirefly connector has about 4 times higher resistance than the Gardner Bender. Granted, at 0.44 mOhm, it is not going to affect your connection much (though the thinness and flimsiness surely will, especially after repeated reconnects). However, I just paid $21 for this on the premise that it’s somehow better than $5-$8 packs elsewhere on Amazon - it isn’t. Most likely, this is the same generic, low quality stuff repackaged with a fancy label.

The barrel is way too small for normal crimping tools. Ancor makes a much better product for the price. You get what you pay for. Too late to return. Oh well, in the trash.

The crimp power is so low that i pulled out ever crimp i made until is started heat shrinking before testing. Even with the heat shrink fully shrunk, it will pull out just not as easily. Would not buy again.

value for price

Das Produkt ist gut und entspricht der Beschreibung