Performance Tool W134DB 3 Jaw Gear Puller Set, 4-Piece Set (Sizes: 3, 4, 6 and 8-Inch), with Reversible Design for Vehicle Maintenance and Repair, Drop-Forged Steel, Chrome Plating

I used this to pull my steering wheel off my 2001 Z06 corvette. Worked like a charm and made the job super easy!

I was not sure if it was strong enough for what I needed it for but it worked great it will come in Handy for other jobs

It is typical cheap made in china quality, however it is reasonably hefty. I used it to get the tracking bar off my ford f350 in order to replace the bushing that was causing death wobble. It worked like a charm and the old bushing pressed out and the new one in without much trouble on my press. If you are trying to fix death wobble on a superduty truck you need one of these as a typical pitman arm puller isn't quite deep enough. The one thing that disappointed me about this puller is that it can't be used a 2-jaw unit. Oh well, overall it was a good purchase and it didn't break unlike all the harbor freight ones I read the reviews for.

Great value, works just fine and easy assembly

I used this this to pull a wiper arm from my motor home. This tool makes that job easier.

DO NOT BUY! Product came in broken packaging, could’ve either been used or because the plastic sheathing is the most brittle plastic I’ve ever had the displeasure of touching. I’d like to think it’s used, because on my first attempt to use it (pulling a pulley off of a 5/8” shaft) it began skipping the teeth on the center rod under very little load because of the gigantic tolerance faults between the inner diameter threading and the rod. Would not survive any load, look elsewhere.

I wanted to replace the steering wheel on a Club Car Precedent golf cart. No amount of hammering, beating, etc. was pulling that steering wheel loose. I watched the videos, I read the instructions, I used copious amounts of penetrating lubricants. Nothing. 15 minutes with this puller, including setup, and my steering wheel was off. I had a single use for this, and it worked EXACTLY as it should. Fast and (relatively) easy. I shouldn’t have tried so hard before ordering…

Comes apart too easily

all good

Goood

funciono muy bien para desatascar bielas de bicicleta que estaban barridas y no podia usar un extractor normal

Exactly as described, totally fit for purpose.

I tried to change the rear rotors of my C300. Succeeded in the left rotor but failed to remove the right rotor. Hitting the rotor with mallet for 15 minutes was totally a waste of energy. Getting and Mounting this tool on the 12 inches diameter rotor after researched from internet. I turned only 1 and half rounds of the puller, the rotor popped off with a cracking sound. The removal was done within 15 seconds. The puller is a very strong and does an excellent job for me. This is my first time to do the 100% brake job on my own.