79193 Spin Mop 4 Heads Included, Basic, Blue

I love this mop, you can clean without putting as much effort as the other old mops.

Works great

I bought to use for at home car washes. The fibers on the mop heads frayed quite a bit but I was using it on my car. The bucket spun well and easily and the mop handle was easy to use. I can’t compare it to any other spin mops but it’s good enough for what I wanted.

I didn't know mopping had gotten so advanced! Dear lord I have been using brute strength 💪 to get my mopping wrung out, this is so easy! Just remember to swab the deck and mopping up the yuck water! It works best like this!

I get so tired of writing reveiws for bad products.First of all it's a very small.mop etc.Secondly it's a very poor product design the spinner unit is in the handle which you have to unlock and.lock to spin the head.Not at all would I consider this unit a sturdy cleaning implement. I won't send it back because I'm just so tired of doing that on less than quality items.Amazon you dropped the ball once again and I'm close to using other sites to order product or go directly to trusted suppliers..

Flemsy

I have had several spin mops, but this is the lightest, simplest and most useful so far. I don't always take "Amazon's Choice," but this unit had what i wanted after the bearing in my old spin mop froze and left me "mopless". First, it has a stainless steel spin basket. Second, it lacks a foot pedal, which requires a one-way bearing and a seal to the foot mechanism, and third, it had a stainless steel handle. All of these details make it more durable, even though the bucket is light plastic. The foot pedal was always a problem for me, and usually had to be repaired after a month of use. With no foot pedal, a two-way bearing is more durable, requires no seal, and reduces the weight. I realized that in reviewing some very expensive models, no foot pedal was provided. The reviewers who complain do not understand how to use the spin mop. After you fill the tank to the level of the pillar (about a gallon) and add 3 oz of Armstrong Once n Done, you loosen the latch on the handle and CENTER the mop in the water side, then push the handle down firmly, wetting the mop with a few turns. Lock the handle latch and wet the floor with a spinning motion--in either direction, covering as much floor as you can handle and letting it stand for 5 minutes. Then replace the mop in the water side and slowly spin a few times again. Then loosen the handle latch and place the mop in the spin basket, being careful to center and match the mop base to the center insert. Now forcefully push down repeatedly, 2 or 3 times per second, getting up to 600 rpm. This removes 95% of the water in the mop--which can hold 1 liter of water. Finally, wipe up the cleaning water in a spinning motion at about 45 degrees (or until the mop spins easily.) Repeat until the room is finished. I wear a clean pair of sketchers to wet the whole floor, then wipe it dry--in several spin cycles. I do three small rooms in 20 minutes. No disposables other than the cleaning solution and the water. There is no better method!

Love the product, easy assembly and use, buy and buy again