PEM202

Good price. Works as it should. Decent quality. Buy it.

Old compressor in my garage. Something broke my ole gauge and I didn't bother to fix initially as the brand is scarce. Perfect fit as it is a common size fitting. Works perfectly and looks much better than a broken one. Same size as original. Very pleased with this purchase.

Was low priced and works well

Very good gauge, going on my 3rd because I can get careless at work and drop or over pressurize. But, for your hard working dollar it's worth it if you take care of it. I use mine from shop air, to a 90 degree valve, to a pressure regulator, then the Winters gauge, to an air chuck. I use this gauge to pressurized and monitor coolant systems on diesel transit coaches. I use this to apply only 16psi or 11psi depending on engine, to find coolant leaks, and to verify repairs. Apply the specified pressure, cut off shop air, monitor gauge, hopefully the needle holds after repairs. Easy peasy. When I break the next one, I'll just buy 2 at a time. Just wish they offered a rubber boot of some sort.

When my first one arrived, it was showing 7 PSI out of the box. I did not even connect it. I contacted Amazon for a replacement. This is being used in an assembly that allows me to air up/down two tires at a time. We do off-roading and the ability to air up/down two tires at a time is a good thing. It also allows me to balance the pressure between the two tires. I also have the ability to check the line pressure with a regular tire gauge (just a back up). I have one electronic and two manual tire gauges that I use. All three of these read exactly the same at 40-65 PSI. The replacement gauge arrived two days later. It was at 0 PSI out of the box. I installed it and started checking...thinking a gauge at this price point would be way off. Actually what I found after testing it with my three tire gauges was impressive. At 40 PSI and below it reads about 1 PSI low. At 50-65 it reads exact to about 1/2 PSI high. I have used high-end, expensive, oil filled gauges that were no where this accurate. Bottom line...I am very pleased with the replacement and glad that I decided to stay with the same brand/seller, etc. Thanks!

My wife bought a used Hayward pool pump and filter, when I started to set it up I realized that the pressure gauge was broken. A little research showed that a replacement from Hayward was an overpriced piece of junk, so I searched and found the Winters line of gauges. So far it's working great, lets me know when I need to backwash the sand filter when the pressure is reduced. That's what it's supposed to do.

Works great

For the money I expected leaks or incorrect readings. However, at a tenth the price of what my local plumbing supply house wanted for a guage, it was worth a shot. It’s been in a month so far, no leaks, reading makes sense, all I need.