DOCA Gardening Tools 6-26 Ft - Extension Pole for Tree Trimming, Fruit Picker, Roof Rake for Leaves - Pole Saw

The other reviews are spot on. This little thing is a beast. I had a 30 foot limb about 20 feet off the ground that was a hazard and needed taken down. I was able to get the entire thing down with this saw. Description says for limbs up to 8 in. I went through 12 in honey locust limbs with it. The cut was smooth enough that it was almost like I had sanded. This thing probably saved me $2,000 in tree work. 10 out of 10 would buy again.

This little blade worked so well. I had a broken bough about 8 inches in diameter, and it was up about 15 feet or so. I have a couple extension poles and this saw fit on both. I taped the handle to the pole to prevent it from spinning loose. That was a little tricky because there is a butt on the handle for gripping, but I was then able to saw off the broken bough with ease. The teeth and shape of this saw was perfect for the task. My husband then used it as a hand saw to quickly cut up this 9 foot in length and full ponderosa pine branch for the trash. Great saw.

this rake head on a quality paint pole is an awesome tool. got a deck that gets leaves under it - this can squeeze into places your blower or conventional rake can’t get. I have made all sorts of contraptions from 3/4” or 1” pvc with a rake handle named in side to taping a broken rake to a paint stick. No more, this can get supper narrow or wide depending on the need. so what’s my gripe? the set screw needs to be relocated. It currently sits on the bottom of the rake (6 o’clock). it it were I stead located at 3 or 9 o’clock it would not damage the surface you are raking. I can get leaves off of low sloped shingle roofs with this but I have to be extremely careful so I don’t scratch/damage the roof. if the wing nut was on the top (12 o’clock) it could break or damage surfaces when you go under something- on the side would be perfect!highly recommend.

great fruit picker very good value!

Works great with the pole and it is adjustable. See other review.

The locking system out of the box is really poor and slips alot. You can tighten it up with a screwdriver to solve this.Its really flimsy/bendy when everything is extended. You have to make sure each segment is not fully extended, only say 3/4 extended. It reduces its maximum length but helps alot with flexing.The saw sucks. It just plain out sucks. The kerf is too small so it gets jammed easily. The amount of strength required to do an undercut some 20~ feet in the air with this thing is absurd. You'll get gassed out after 2 branches. If the kerf was wider it wouldn't get stuck so easily.Anyhow, when your cutting, pay VERY close attention to how harder each cut gets. If it does, pull the saw all the way out and start cutting back down again to avoid it getting pinched/jammed in there.There is no way to change angle of the cut when its really high up. The best you can do is go at it from the other side. This helps tremendously when doing bigger branches.The saw needs the weight of the branch to make any sort of progress. It the branch is jammed or hung up on other branches and can't sag down, sawing will be extremely difficult. It will feel as if the blade isnt sharp enough when you try to cut. Try to untangle the branch so gravity can help you when your cutting.Reeeealy wish the saw had a wider kerf.Now the pole itself i would rate 4 stars, its a great pole, minor issues i explained above. But i bought it to be main use as a polesaw, so i rate 3 star. The duster attachment is great for spiderwebs on cameras.

Tighten the screws on the section locks and if possible, don't extend the very first section. It is kind of thin and has the possibility of bending. The saw works great. Overall very good product for my needs

Broke while threading onto my pole for the very first time.The grey plastic piece, which is the female threaded end, is inserted into the green handle and held in place with a plastic pin, which snapped off while I was about 2 turns into threading onto my extension pole. I can still thread the grey piece onto the pole, but there is nothing holding the green handle now.Pretty sure on the first pulling motion while cutting a palm branch my saw is going to be stuck 15 feet in the air with no way to get it down, so I'm not even going to attempt itReturning this one and buying a different brand. I don't have time to wait another 3 or 4 days for a replacement that will break just like this one.Poor design on the threaded handle. Blade looks sharp but I'll never know if it cuts anything now.Disappointed and I'm not recommending this to anyone.